User manual AEG-ELECTROLUX EHG8830X

[. . . ] Before carrying out any hob cleaning or maintenance, always unplug the appliance or disconnect the power by means of the main switch. ⷠNever use steam appliances, scouring pads, steel wool, muriatic acid or other products which could scratch or mark the surface. Never use sharp objects, as they could damage the seals between the trim and worktop. ⷠDo not use products containing sands, alkalis, acids, chlorides, oven sprays, detergents usually used cleaning dishwashers. [. . . ] Do not allow children to touch: ⭠­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ the controls or the appliance in general; the packing components (bags , polystyrene , staples , etc. ); the appliance, during and immediately after use, since the hob becomes very hot; an unused appliance (make any potentially hazardous parts safe). Touch the appliance with wet parts of the body; use the appliance when barefoot; pull the appliance or power cable to unplug it; carry out improper or hazardous operations; leave the power cables of other electric appliances on hot parts of the appliance; expose the appliance to atmospheric agents; use the appliance as a support surface; use flammable fluids near the appliance; use adapters, multisockets or extension leads; allow anyone except qualified personnel to install or repair the appliance. Do not place unstable or deformed pots on the burners, since they may tip over or cause spills. If the appliance has a lid, make sure the burners are cold before closing it. Close the gas supply cock when the hob is not in use. Before installation, make sure the gas supply is compatible with appliance specifications. The arrangement for the gas usable is given on the label on the bottom of the tray. This appliance is not connected to a fume extraction device and must be installed and connected in compliance with the current regulations. pay particular attention to the applicable regulations on ventilation. The use of a gas cooking appliance produces heat and humidity in the room where it is installed. Ensure the room is adequately ventilated: keep natural ventilation openings open, or install a mechanical ventilation device (extractor hood with exhaust duct). In case of intensive or prolonged use of the appliance, it may be necessary to provide additional ventilation, for example by opening a window, or more efficient ventilation, by increasing the fan speed (if present). The manufacturer declines any liability for damage due to: incorrect installation, improper, wrong or unreasonable use. The necessary operations for installation, including gas and electrical connections, are described below. Such operations must be carried out by qualified personnel in accordance with current regulations, since their performance by unskilled people may constitute a hazard. The manufacturer declines any liability for injury or damage due to non-compliance with these provisions. This handbook regards a class 3 built-in cooking hob. Prepare the opening in the top according to the measurements given in fig. The opening must be made in the most convenient position, taking into account that the gas pipe must not come into contact with the sides of a possible oven under the hob. [. . . ] Power and current) are compatible with those of your Electrolux hob. If a different type of gas is to be used, change the injectors as follows: Unscrew and remove the injectors and replace them with those supplied, corresponding to the mains gas, making sure the marking is that given in the table (page 17); 3. refit the flame-spreaders , burner caps and grates; 4. These burners do not require air adjustment. [. . . ]