User manual AEG-ELECTROLUX EHG978WLP

[. . . ] INFO INSTRUCTION i MANUAL BUILT-IN HOB Models: EHG678* · EHG978* · EHM684* · EHM984* · EHG977* · EHG983* · EHG682* · EHG982* *Denotes colour: W=White, X=Stainless Steel i INSTRUCTION MANUAL Congratulations and thank you for choosing an Electrolux Product. We are sure you will find your new cooktop a pleasure to use and a great asset to your cooking. Before you use the cooktop, we recommend that you read through the whole user manual which provides the description of the cooktop and its functions. To avoid the risks that are always present when you use a gas or electric appliance, it is important that the cooktop is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. [. . . ] Repeat lighting procedure and hold knob down for 5-10 seconds. Check that the controls are set correctly. The cleaner will cure and there will be no more smoke. Contact installer. Flames uneven or tending to lift. Flame not staying on when knob released. Electric element not working. Smoking hotplate. Low heat, slow cooking. Flame won't turn down sufficiently. Benchtop overheating. Flame goes out on low setting. Incorrect cooking utensil being used. Incorrect injector or gas control valve incorrectly adjusted. Gas pressure too low. Yellow flame with Wok burner. Check Fig. 3 for correct utensil to be used. Contact installer to correctly adjust regulator. Contact service to adjust by-pass screw. If soot deposits are evident on wok contact service to reduce injector size. INSTALLATION INSTRUCTIONS This is a Category II, Class 3 appliance. This appliance must be installed by an authorised person and in compliance with: i. The local gas fitting regulations, municipal building codes, electrical wiring regulations and any other relevant statutory regulations. The particular instructions as given below. Before commencing installation, check to ensure that the appliance gas type given on label next to gas connection on appliance corresponds with the type of gas to which it is intended the appliance be connected. This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation. During installation the following points should be noted. THE BENCH CUTOUT should be made as per `BENCH CUTOUT SIZE' table (Fig. ADJACENT WALLS, CUPBOARDS AND PROTECTION FOR COMBUSTIBLE MATERIALS: Ensure that overhead cupboards and any combustible material e. g. curtains are a minimum of 1000mm from the cooktop. [. . . ] The appliance inlet pressure for each gas type is also shown. BURNER BOX To convert the appliance for use with Citigas follow the conversion procedure. A Qualified Technician should carry out this procedure and use a Conversion Kit available from Electrolux The Kit contains · One injector for each hotplate burner with the size indicated in the table. · One aeration calibrator per hotplate burner. To carry out the conversion or to access components within the appliance for service follow these instructions. [. . . ]