User manual AEG-ELECTROLUX EHG9830X

[. . . ] These instructions are only valid in the countries whose symbols appear on this booklet's cover. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. [. . . ] ⷠIf the fixing bracket is near to the terminal block, always make sure the connection Cable does not come in contact with the edge of the bracket. ⷠYou must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. dISPOSAL OF THE APPLIANCE · To prevent the risk of physical injury or damage ­ Disconnect the appliance from the power supply. ­ Cut off the mains cable where it connects with the appliance and discard it. ⭠Flat the external gas pipes if there are fitted. ­ Speak to your local authorised facilities for disposal of your appliance. The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. GAS CONNECTION Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Screw the parts without force, adjust the connection in the necessary direction and tighten everything. 1 End of shaft with nut 2 Washer (additional washer is only for Slovenia and Turkey) 3 Elbow 4 Rubber pipe holder for liquid gas (only for Slovenia and Turkey) Flexible nonmetal pipes connection: If it is possible to easily control the connection in its full area, you can use a flexible pipe. The flexible pipe is prepared for apply when: ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Data" chapter). Assemble the parts, follow the same procedure backwards. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this plate in the package supplied with the appliance. [. . . ] Clean the appliance with a damp cloth and some detergent. At the end rub the appliance dry with a clean cloth. To make burners work properly, make sure that pan supports are placed in the way that the arms are centred upon the burner. In order to avoid damaging the hob top pay attention when replacing the pan support. [. . . ]