User manual AEG-ELECTROLUX EHGC95ASWC

[. . . ] electrolux e:line gas cooktops safety instructions 1 General Warnings Please read the user manual carefully and store in a handy place for later reference. Pass the user manual on to possible new owners of the cooktop. The symbols you will see in this booklet have these meanings: warning This symbol indicates information concerning your personal safety caution This symbol indicates information on how to avoid damaging the cooktop tips and information This symbol indicates tips and information about use of the cooktop environmental tip This symbol indicates tips and information about economical and ecological use of the cooktop Meanings of symbols used in this manual are shown below: This symbol indicates never to do this This symbol indicates always do this caution Read the following carefully to avoid an electric shock or fire. It is important to use your cooktop safely. [. . . ] Trivets and burner caps These can all be lifted off and removed for separate cleaning. When refitting the burner caps, ensure that they are correctly seated. Ensure burner caps are thoroughly dried after cleaning or spillage. When cleaning the burner caps, ensure that all the flame ports are free of any blockage. IF necessary, use a toothpick or brush to clear ports. The outer surface of the burner caps have a polished finish and extra care needs to be taken to avoid scratching this surface during cleaning. In instances of heavy soiling, it may be necessary to apply a non-abrasive cleaning compound and rub with a cloth until the soiling is removed and then finish with a soft, dry cloth. DO NOT place burner caps in the dishwasher. Ignition spark plug and flame safeguard sensor GEnTLY clean the ignition spark plug and flame safeguard sensor with a damp cloth to avoid lighting difficulties. Ensure that they are dry before use. EGASCOOKTOPUMAN txt may09. indd 4 8/5/09 12:32:43 PM electrolux e:line gas cooktops troubleshooting 5 Troubleshooting If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will save you from paying for a service call. You will have to pay for a service call even in the warranty period if the problem is one listed below. Table 1 Fault Possible Cause Knob not held down long enough in `HIGH' position for flame safeguard. Burner will not light even though the sparker is working. Electricity supply is disconnected or switched off. Knob not held down long enough in `HIGH' position for flame safeguard to engage. Flames not staying on when knob is released. Knob not set between `HIGH' and `LOW'. Dirt or spillage on flame safeguard sensor. Incorrect cooking pot or pan being used. Pot or pan not located on burner properly. Ensure pot or pan is centrally located on burner. [. . . ] Turn on the gas and electricity supply and attempt ignition on all burners, both separately and in combination. (For correct procedure refer to page 2 Lighting Burners). Note that additional time needs to be allowed for the initial lighting as air has to be purged from the pipes. Observe the flame appearance on each burner (Figure 10). [. . . ]