User manual AEG-ELECTROLUX EHM6335K

[. . . ] user manual Mixed hob HR CZ RU SK SI TR EHM6335 2 electrolux Electrolux. Thinking of you. Share more of our thinking at www. electrolux. com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 7 7 8 Care and cleaning What to do if. . . Technical data Environment concerns 9 10 11 12 Subject to change without notice SAFETY INFORMATION Warning!These instructions are only valid in the countries whose symbols appear on this booklet's cover. [. . . ] Tightly attach the flexible pipe by clamps. The flexible pipe is prepared for apply when: electrolux 5 ­ it can not get hot more than room temperature, higher than 30°C; ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. Remove the caps and crowns of the burner. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in Technical Data section). Assemble the parts, follow the same procedure backwards. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this plate in the package supplied with the appliance. If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pressure adjuster on the gas supply pipe. Adjustment of minimum level To adjust the minimum level of the burners: 1. Remove the control knob. 1) only for Russia 4. With a thin screwdriver, adjust the bypass screw position. 1 1 The by-pass screw ­ If you change from natural gas 20 mbar (or natural gas 13 mbar 1)) to liquid gas, fully tighten the by-pass screw in. ­ If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw approximately 1/4 of a turn. ­ If you change from natural gas 20 mbar to natural gas 13 mbar1) undo the by-pass screw about 1/4 of a turn. ­ If you change from liquid gas to natural gas 13 mbar1), undo the by-pass screw about 1/2 of a turn. ­ If you change from natural gas 13 mbar1) to natural gas 20 mbar to tighten the by-pass screw about 1/4 of a turn. Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. Electrical connection · Ground the appliance according to safety precautions. · Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. · This appliance is supplied with a mains cable. [. . . ] Cleaning of the spark plug This feature is obtained through a ceramic ignition candle with a metal electrode. Keep WHAT TO DO IF. . . Problem There is no spark when lighting the gas Possible cause · There is no electrical supply Remedy · Make sure that the unit is connected and the electrical supply is switched on. If the fuse is released more than one time, refer to a qualified electrician. · Make sure that the burner cap and crown are in correct positions. [. . . ]