User manual AEG-ELECTROLUX EIW63810X

[. . . ] User Manual Refreshment Centre EIW63810X 2 electrolux Contents Safety information Appliance description Main components Rating plate Technical specifications Package content Installation 2 4 4 4 5 5 6 Unit positioning Unit connection Usage Maintenance and cleaning Signals for users What to do if. . . Environment concerns 6 9 11 13 17 18 19 Safety information Fundamental safety warnings Warning The appliance must be earthed in compliance with legislation. Electrical and Water connection must be carried out by qualified technicians following the instructions Warning Keep all packaging (plastic bags, polystyrene foam) away from children Warning The appliance is not to be used by people (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Warning In order for children not to play with the appliance, a close supervision is required Warning Do not grasp the appliance when it is out of the cabinet. Do not rest recipients containing liquids or inflammable or corrosive materials on top of the appliance Warning Do not use the appliance when extracted, except for installation, maintenance and "What to to do if. . . " sections. [. . . ] Regulate water inlet pressure Warning The pressure reducer must be opened only when the installation process is complete and the appliance is switched on Pressure has to be regulated between 2 and 3 bar operating on the plastic knob. To regulate the pressure, pull up the water plastic knob. While dispensing ambient water: for pressure increase rotate the knob clockwise, for pressure decrease rotate it counter-clockwise. Once the regulation has been made, push the knob back to its security position. Regulate CO pressure Warning The pressure reducer must be opened only when the connection process is complete and the appliance is powered up Warning When changing CO pressure, the adjusted sparkling level will be reached after dispensing 0. 5 litres of cold sparkling water Warning CO pressure can be adjusted to a maximum of 4 bar 1 Water plastic knob 2 Water pressure gauge Make sure that the tap between the water mains and the flexible hose is open. After any pressure regulation, verify the new adjusted level by dispensing a little water. 1 CO plastic knob 2 CO pressure gauge CO pressure can be adjusted using the pressure reducer placed on the CO bottle. Pressure has to be regulated 0. 5 bar above inlet water value operating on the CO plastic knob. For pressure increase rotate the knob clockwise, for pressure decrease rotate it counter-clockwise. electrolux 13 Dispensing during first start-up During first start-up ambient water is immediately ready. The first ice shards will be ready after 90 minutes. The ideal temperature for cold water will be reached after 2. 5 hours. The ice tank will be fully loaded after 5 hours. Dispensing during normal usage Warning Do not insert any object in the ice shards nozzle. This may damage the section with consequent ice melting In order to fill a big bottle or jug, carefully pull out the water dispense nozzle. Place a glass on the drip tray, then select the desired beverage or the ice shards. Press the icon until the desired amount has been dispensed. Dispensing is indicated by the LED corresponding to the pressed icon. Dispensing from water nozzle is delayed to prevent accidental leakage. The appliance can dispense 2 litres of cold still or cold sparkling water in 2 hours. The water coolness level may vary if the dispensing time recommendations are not followed. If the ice has been entirely dispensed, fresh ice shards will be available after approximately 40 minutes. The ice tank will be fully loaded after 2. 5 hours. Illumination of the Refreshment Centre For a more comfortable dispensing process, press the light LED of the control panel and switch on the central ambient light. Maintenance and cleaning Warning If the appliance remains switched off for over 8 hours it is necessary to drain the water tank Warning A monthly drainage of the water tank is needed to guarantee the correct quality level Warning Carry out a cleaning of the appliance every six months to ensure the correct quality level Warning Use food grade CO bottle Drainage of the drip tray To prevent water leakage, keep the drip tray clean and dry. 14 electrolux Drainage of the water tank Warning If you had to stop pressing the power icon, please press it again and keep it pressed in order to complete the step Warning After the procedure always remember to close the water discharge tap to avoid water leakage 10. Push back the appliance until it is locked into position Food grade CO bottle replacement Warning While screwing on the new CO bottle, CO leaks might occur 1. Dispense all the available ice shards 2. Remove the grid of the drip tray to easily pull out the Refreshment Centre. [. . . ] Hold the cleaning cartridge from the upper larger side and insert it in the filter head by pushing it up and rotating it counter-clockwise 7. Connect the plastic hose to the discharge water nozzle 8. Place a big container underneath the plastic hose or put the hose in a sink 9. Place a cup under the water dispense nozzle 10. Remove the safety screw and open the water discharge tap electrolux 17 11. Turn on the power switch 12. Immediately press the light icon and keep it pressed until LEDs start scanning If the power LED became steady, please repeat the two last steps until LEDs start scanning 13. Wait for the power LED to flash, then press the power icon until the LEDs start scanning again Some water will be dispensed from the water dispenser automatically 14. Wait for the power LED to flash, then remove the cleaning cartridge Water may come out from the cleaning cartridge. [. . . ]