User manual AEG-ELECTROLUX EK13810LWE

[. . . ] S If you have been supplied with a dama- Ged unit please contact your supplier immediately. S Repairs and other service work must only S When cleaning switch off the power Supply; pull out the power supply plug or deactivate the fuse. Never pull the plug out of the socket by pulling on the cable or with wet hands. Always grip the plug itself and pull it straight out of the power supply socket. [. . . ] Attention: do not use sharp implements to remove ice or anything hard frozen. do not use an electrical heater or an open flame for defrosting. ­ After defrosting clean the interior and dry it thoroughly. ­ Move the temperature back to Position Normal between the two temperature symbols. By pressing both holders sideways at the same time, the glass shelve can be swung upwards and removed. To fixture the glass shelf: push the glass shelf back into the holder and, at the front, press it down into the holder. It should be washed out from time to time with a mild soapy solution and then dried. an occasional wiping of the refrigerator with a vinegar solution suppresses odours and is recommended. Keeping the door seals clean stops them from sticking and thus avoids them being damaged. no scouring cleaners or scratching cloths are to be used. If the refrigerator has not been used for some time, set the ­temperature controller to position «0». Empty the refrigerator, defrost it, clean, and then leave the refrigerator as well as the freezer compartment open. ­ Be careful that no cleaning water can get into the controller housing (danger of short circuit). ­ Be careful that as little cleaning water as possible goes though the drainage channel into the collection dish. ­ Before being put back in use, the unit and the seals of the refrigerator and the freezer compartment must all be completely dry. Shelves if products are stored which emit water vapour. S Be careful that products do not come Into contact with the rear wall of the refrigerator so that they do not freeze to it and that, during defrosting, water does not get diverted into the refrigerator. With liquids; never measure the air temperature. Tips The following points should be noted when using the new refrigerator: S The unit should not be installed near ­ Oil and fats do not come into contact with the polymer parts and the door seals. ­ The coldest locations in the refrigerator for any setting of the temperature controller are at the back wall and above the lowest shelf. [. . . ] Normal operating noise as coolant flows through the circuit. Normal operating noise as coolant is injected into the condenser. Arrange the shelves and contents so that they are fixed and not touching one another. Electrical safety (personnel protection safety) is to be ensured during fitting. [. . . ]