User manual AEG-ELECTROLUX EKC60050X

[. . . ] - This appliance must be installed in accordance with the regulations in force and must only be used in well ventilated rooms. Consult the instructions booklet before installing and using the appliance. - This household appliance has been designed for cooking and it must therefore be used for this purpose only. dEAR CUSTOMER , · Carefully read these instructions before using the appliance and keep them for future consultation. [. . . ] Whenever possible, keep a lid on the pan while cooking. With as little water as possible to reduce cooking times. TAPS REPLACEMENT Act as follows: switch the appliance off, and close the general tap open the work-top and disassemble also the control panel as described on the previous paragraph. Note: Every time the tap is replaced, it is necessary to replace the seal gasket too check the connection seal by means of soapy water (see picture). It is possible to select the desired temperature into the oven by turning clockwise the thermostat knob and depending on the models, one or more functions: Oven off Oven light 60 ÷ Use of the oven Note: ovens with separate thermostat and commutator. When the functions are used, place the thermostat knob between 180 ÷ 200°C as maximum temperature. ATTENTION: The temperature shown on the control panel corresponds to the temperature in the oven centre only when the functions selected are or . When you turn the control knob to this position, the light will be on for all the following operations. The yellow/green earth wire should not be controlled by the switch. The plug used for mains supply connection should be easy to get at, once the appliance is in position. Important: position the mains supply cable so that it is never subjected to a temperature which is more than 50°C above ambient temperature. Make sure that the flame does not go out passing quickly from the max. 10A WARNINGS Isolate the cooker from the electricity supply before attempting to replace the oven lamp. In particular when there is only this gas appliance in the room, there must be a hood over the appliance to ensure the natural and direct removal of spent air, with a vertical straight duct of length equal to at least twice the diameter and a minimum section of at least 100 cm2. For the indispensable entry of fresh air into the room there must be a similar 100 cm2 opening directly to the outside, situated at a height near floor level so that it is not blocked either inside or outside the wall and so as not to cause disturbances to correct burners combustion and to the regular removal of spent air and with a difference of height with respect to the outlet opening of at least 180 cm. Remember that the quantity of air necessary for combustion must never be less than 2m3/h for each kW of power (see total power in kW on the appliance data plate fig. When there are other gas appliances in the same room, or when natural direct ventilation is not possible and natural indirect or forced ventilation must be installed, contact a qualified specialist who will install and make the ventilation system, scrupulously observing the regulations contained in the standards in force. The openings must be so positioned that there are no draughts of air which cannot be tolerated by the occupants. Moreover to eliminate combustion products, it is forbidden to use flues already used by other appliances. 3 ) by flexible tube in stainless steel with continuing wall, with mechanical connection in accordance with rules. 2 WARNINGS Concerning rubber flexible tubes, we remember you: 1 - to avoid the tube to be narrowed or crushed 2 - do not submit it to traction or torsion efforts 3 - to avoid contact with sharp edges, etc. 4 - to avoid contact with parts reaching temperatures over 70°C the ambient temperature 5 - to ensure that they can be checked for all their length. [. . . ] Do not leave any acid or alkaline substances (lemon juice, vinegar, salt, etc. Clean the parts in stainless steel with specific cleansers for stainless steel surfaces. These detergents must be applied using a soft cloth. GRIDS AND BURNERS To clean the work-top burners, remove them by pulling upwards and soak them for about 10 minutes in hot water with a little detergent. [. . . ]