User manual AEG-ELECTROLUX EKM90355X

[. . . ] ) and dispose of them in accordance with local waste disposal laws. This appliance complies with the following European Directives: - 73/23/EEC regarding "Low Voltage". - 89/336/EEC regarding "Electromagnetic Disturbances". - 90/396/EEC regarding "Gas appliances" - 89/109/EEC regarding "Materials in contact with food" - Moreover the above mentioned Directives comply with Directive 93/68/EEC. [. . . ] Important: position the mains supply cable so that it is never subjected to a temperature which is more than 50°C above ambient temperature. The electrical safety of the appliance can only be guaranteed when it has been correctly connected to an efficient earthed power supply, as laid down in the regulations for electrical safety. Important: the manufacturer cannot be held responsible for any damage to persons or objects due to the lack of an earth connection. If the cable is damaged, fit a replacement in the following way: - remove the mains cable and replace it with one of the same length which is rubber insulated and suitable for the power rating of the appliance. The "yellow/green" earth wire, which must be connected to terminal , has to be about 10 mm longer than the other wires; the "blue" neutral wire has to be connected to the terminal marked with letter N. The live wire must be connected to the terminal marked with letter "L". To replace it, act as follows: disassemble the protecting glass (A) and replace the burnt lamp with one of the same type. Fan assisted total grill The air which is heated by the grill heating element is circulated by the fan which distributes the heat on the food. the fan assisted grill replaces perfectly the turnspit. You can obtain very good results also with large quantities of poultry, sausage, red meat. Conversion to LPG Always isolate the cooker from the electricity supply, turn off the gas supply temporarily and proceed as follows. - change the injectors , - adjust the minimum flow of the burners. REPLACEMENT OF WORK-TOP INJECTORS In order to change the work-top injectors, it is necessary to act as follows: remove the grids, remove burners and flame-spreaders (see fig. B) and replace it with another one suitable for the new type of gas (see table D). Reassemble everything in the opposite direction, paying attention to place the flame-spreader in the right way on the burner. Air forced lower heating element The air which is heated by the lower heating element is circulated by the fan which distributes the heat on the food. This function can be used to sterilize food. This function can be used between 60 and MAX°C Install the grid on the third shelf from the oven bottom, at about 12 cm from the surface. The user can change the shelves, depending on his personal whishes and on the different food. DISASSEMBLE OF WORK-TOP In case it is necessary to repair or replace the inside components, act as follows:remove the glass lid from its position slipping off it upwards. It must therefore be installed and connected in conformity with the installation standards in force. Particular attention must be paid to the standards on ventilation of the room. [. . . ] After having cleaned and washed them, wipe them carefully. make sure that no burner hole is clogged. Clean the burners once a week or more frequently if necessary. mAKE SURE YOU HAVE ASSEMBLED THE BURNERS IN A RIGHT WAY. [. . . ]