User manual AEG-ELECTROLUX EL4307A

[. . . ] UltraActive OWNER'S GUIDE ENGLISH IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. Close attention is necessary when used by or near children. [. . . ] Hard Floors : Use the bare floor brush (1). Use `Brushroll OFF' setting for wood, tile, or other hard-surface floors. Do not use `Brushroll ON' setting for hard-surface floors, as the brush roll could damage delicate surfaces. Turn off brushroll when cleaning barefloors. After connecting the power nozzle to the wand and hose, turn on the canister and the brushroll for carpet cleaning (page 6). The cleaning height can be adjusted by pressing on the height adjustment pedal located on the rear of the hood (Fig. The height indicator will change from low to medium to high as you make the adjustment. C) Use the lowest setting that still allows easy maneuvering on the carpet. Release the handle by pressing down on the handle release button (Fig. (C) (B) (A) Do not use the power nozzle on the fringes of rugs without first turning off the brushroll. Turn off the cleaner when it is not in use. Do not let the power nozzle stand in one place while running for an extended period as it could cause carpet damage. Avoid running the power nozzle over the cleaner's electrical cord. if carpet fringe or an object (sock , etc. ) is caught in the nozzle and prevents the brushroll from turning, a safety cut-off will engage. In addition, the nozzle's headlight will turn off and a red light on the powerhead (Fig. D) will indicate that the power to the nozzle has been interrupted. ENGLISH CAUTION: To reduce the risk of injury, unplug before servicing­the brushroll could suddenly restart. Do not use the dust container handle to carry the cleaner. Never use the vacuum cleaner without filters. For service not described in this manual take to Electrolux Authorized Service Center for repair. EMPTYING AND CLEANING THE DUST CONTAINER Periodically, lift out the dust container to check that the cup is not is not filled passed the max fill line. [. . . ] Insert the belt end of the brushroll back into the case, followed by the other end. Reinstall the cover by "snapping" it back into place and replacing the four screws. COMMENT REMPLACER LA COURROIE (TYPE DE BROSSE EL097) ATTENTION: Unplug the cleaner before replacing belt. 13 ENGLISH TROUBLESHOOTING AND CONSUMER INFORMATION FRANÇAIS GESTION DES PANNES ET INFORMATIONS CONSOMMATEUR ESPAÑOL SOLUCIÓN DE PROBLEMAS E INFORMACIÓN AL CONSUMIDOR CAUTION: To reduce the risk of injury, unplug before servicing­the brushroll could suddenly restart. [. . . ]