User manual AEG-ELECTROLUX ELM5100GR

[. . . ] € Never leave the appliance unattended while connected to the supply mains. € The appliance and accessories become hot during operation. Allow to cool down before cleaning or storage. € The mains cable must not come into contact with any hot parts of the appliance. [. . . ] Lift the lever, insert a capsule in the compartment. Close the lever and press the Espresso button. When the desired amount of coffee is reached, press the button again to stop. When the coffee is ready, lift the lever and the capsule falls down into the used capsules container. Turn the knob to steam/hot water position, and turn it back to stop. Steam can be used to froth milk or to heat liquids. Place an empty container under the spout. Turn knob to steam position for a few seconds to purge residual water. Immerse the steam spout into the milk and open the knob. Froth the milk by swirling the container. Always use the plastic handle when touching the steam spout. To prepare coffee, insert a capsule, close the lever and press the Espresso button (there is a short cooling cycle before the coffee comes out). Turn the machine off, unplug the cord and let the machine cool down. wipe all outer surfaces with a damp cloth. When the floating indicator is visible above the grid, the drip tray must be emptied. Lift out grid, tray and waste container. Empty, rinse, dry and put back in place. This procedure should be carried out every two or three days or after 10 brewed coffees. The cup support rack, drip tray and used capsules container are all dishwasher proof. Pull the spout fully down and remove it by pulling it towards you. After using the steam spout, dispense steam for a few seconds. Clean the spout externally with a damp cloth. [. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Når maskinen startes for første gang: Placer en skål under damp-/ varmt vandshanen og drej knappen til positionen for damp/varmt vand. For at klargøre kredsløbet skal du anbringe en skål under varmvandsrøret og dreje knappen til positionen for damp/varmt vand. For å fylle opp vannkretsen plasser en bolle under varmtvannsrøret og skru bryteren til posisjonen for damp / varmt vann. [. . . ]