User manual AEG-ELECTROLUX ELM5200CB

[. . . ] € Never leave the appliance unattended while connected to the supply mains. € The appliance and accessories become hot during operation. Allow to cool down before cleaning or storage. € The mains cable must not come into contact with any hot parts of the appliance. [. . . ] Close the lever and press either Espresso or Espresso lungo button. When the coffee is ready, lift the lever and the capsule falls down into the used capsules container. press and hold the espresso or espresso lungo button. Release when desired coffee amount is reached. The programmed quantity is memorized by the machine. Turn the knob to steam/hot water position, and turn it back to stop. Steam can be used to froth milk or to heat liquids. Place an empty container under the spout. Turn knob to steam position for a few seconds to purge residual water. Immerse the steam spout into the milk and open the knob. Froth the milk by swirling the container. Always use the plastic handle when touching the steam spout. To prepare coffee, insert a capsule, close the lever and press either the Espresso or the Espresso lungo button (there is a short cooling cycle before the coffee comes out). When the floating indicator is visible above the grid, the drip tray must be emptied. Lift out grid, tray and waste container. Empty, rinse, dry and put back in place. This procedure should be carried out every two or three days or after 10 brewed coffees. Drip tray is not dishwasher proof (paint can be damaged). Turn the machine off, unplug the cord and let the machine cool down. wipe all outer surfaces with a damp cloth. Pull the spout fully down and remove it by pulling it towards you. After using the steam spout, dispense steam for a few seconds. [. . . ] Når maskinen startes for første gang: Placer en skål under damp-/ varmt vands-hanen og drej knappen til positionen for damp/varmt vand. For at klargøre kredsløbet skal du anbringe en skål under varmvandsrøret og dreje knappen til positionen for damp/varmt vand. For å fylle opp vannkretsen plasser en bolle under varmtvannsrøret og skru bryteren til posisjonen for damp / varmt vann. Drej knappen til damppositionen i et par sekunder for at rense for overskydende vand. [. . . ]