User manual AEG-ELECTROLUX ENB34000W

[. . . ] User manual GB refrigerator- freezer combination ENB 34000W We were thinking of you when we made this product GB electrolux 3 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. [. . . ] Be sure that the condenser and the compressor are well ventilated. Do not cover the sections where ventilation is. Wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. Do not leave the door open longer than necessary and avoid unnecessary openings. Put warm foods into the appliance only when they are at room temperature. Keep the condenser clean. Maintenance Defrosting Bleeding part of the moisture of cooling chambers in form of frost and ice goes with the operation of the appliance. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases in the cooling chambers, they need more energy. At this type of appliance defrosting the cooling surface of the refrigerator is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time during this cooling is interrupted - the temperature of the cooling surface goes above 0 °C due to interior heating load of the compartment, so defrosting occurs. When the surface temperature of the cooling surface has reached +3 - +4 °C the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet leaded through the back into the evaporator tray maintained on the top of 14 electrolux GB compressor and evaporates due to its warmth. Defrosting of the freezer is automatic in this model. Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The pipe scraper has to be stored in the outlet. The most typical case of clogging up in the melting water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of the refrigerator and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful because of the above - when placing foods wrapped in paper into the appliance. during heatwaves, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting does not work. Remaining small ice and frost stains on back plate of the refrigerator after defrosting period is not abnormal. GB electrolux 15 Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time using lukewarm water then wipe it (it is practical to clean the inside of the freezer and defrost it at a time). Household cleaner or soap must not be used. After breaking the circuit wash the appliance with lukewarm water then wipe it. After cleaning apply voltage to the appliance. It is recommended to remove the dust and dirt collected on the back of the refrigerator and the condenser and to clean the evaporative tray on top of the compressor once or twice a year. Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. [. . . ] The plug must still be accessible after the appliance has been installed. The appliance should not be connected to the electrical supply by means of an extension cable. In case that the electrical cable has to be replaced, please contact your local Service Force Centre. A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. [. . . ]