User manual AEG-ELECTROLUX ENB43396X

[. . . ] Safety information 2 Control panel 4 First use 5 Daily use 5 Helpful hints and tips 7 How to use the water dispenser with BRITA MAXTRA filter cartridge 8 Care and cleaning What to do if. Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] As required for some other water filter cartridges, there is no need to pre-soak the new Maxtra Cartridge. Unscrew the valve in counter clockwise (pay particular attention not to lose the Valve Gasket because is necessary to a correct functioning of the features ). Clean the tank lid, the valve and the gasket with a solution of warm water and neutral soap. Rinse it and put it inside the door hole during the cleaning of the other components (in order to avoid cold air leakage from the fridge). Clean the tank and the funnel into the dishwasher or with a solution of warm water and neutral soap and rinse them. After the tank components cleaning take back the valve from the fridge door and assembly the tank in the inverse order (4;3;2;1) of disassembly (pay attention at the valve gasket positioning ). Before inserting the cartridge, remove the funnel and clean it thoroughly by rising it and wiping it dry. Then, thoroughly clean the inside of the water tank with a dump cloth and wipe it dry as well. Place the cartridge into the filter tank and push downwards until it 'clicks' firmly into place. The cartridge should stay in place if the funnel is turned upside down. To fill the tank with cold water, simply open the flip top lid, take a jug of tap water and pour it inside the tank through the cover as shown into the picture (use the lid every time that you want to fill your water). In order to avoid risk of spillage of water during closing and opening of the refrigerator door, we recommend to not fill completely the water tank but leave a head space of air (max. refilling limit till the frontal marks). If you have not used all filtered water in the water tank within 1-2 days, please discard any water left inside the BRITA water filter unit before refilling it. Allow the water to filter through and repeat "Step 4" as many times as you want until the BRITA water filter unit is filled up. Remove cartridge with ring pull handle Take the funnel out of the BRITA water filter unit, fill it under the tap with cold tap water and allow it to filter through. Discard the first two fillings into the sink. These first two fillings are used to flush the filter cartridge. Then, place the funnel back into BRITA water filter unit. Place the cover back onto the jug and press it carefully downwards to ensure it fits correctly into place. To exchange the cartridge after four weeks, simply use the ring pull handle on the top of the cartridge to remove it from the funnel, and repeat steps 1 - 3 above. The BRITA Memo For maximum filter performance and optimum taste, it is important to change your BRITA cartridge regularly. [. . . ] The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed. Rear spacers Inside the appliance you find two spacers which must be fitted as shown in the figure. [. . . ]