User manual AEG-ELECTROLUX ENL60710S1

[. . . ] pass the user manual on to possible new owners of the refrigerator. The symbols you will see in this booklet have these meanings: Read the following carefully to avoid damage or injury. This symbol indicates never to do this This symbol indicates always do this It is important to use your refrigerator safely. Check these safety points before using your refrigerator. [. . . ] Pull the shelf forward and allow the rear to drop into the side channels. When replacing the drawers after cleaning, we recommend fitting the lower drawer first. freezer baskets Wire baskets are used in the compact side by side model. All the baskets pull out for easy access and have a stop to prevent the basket being pulled out too far. Push the front shelf backwards until it reaches the rear stops. Repositioning: To reposition shelf, pull forward until shelf reach stops. Lift shelf clear of stops and continue to pull forwards. Once the shelf is clear of the cabinet it can be repositioned onto any of the other runners. To remove the basket, pull it out until it hits the stop then lift the front to unhook the stop while continuing to pull forward, until the basket is free of the runners under the shelf. Deodoriser Your appliance is fitted with a deodoriser to assist with the removal of food odours inside your appliance. Odours are removed by absorption through the filter by the normal operation of the appliance. If the ice maker is connected to soft water, ensure that the softener is maintained and working properly. Dispenser lamp The dispenser has a light which can be turned on and off by pressing the Lamp button on the electronic display (see Diagram below). the lamp is also activated for 6 seconds whenever a dispensing paddle is pressed. The light comes from 6 ultra bright LEDs (Light emitting diodes), which are part of the electronic display and are not customer replaceable. How the ice dispenser works The ice maker and ice container are located in the top of the freezer compartment. After the refrigerator is installed properly and has cooled for several hours, the ice maker can begin making ice and the first batch will be ready within 24 hours. A full tray of ice may not be created for the first few batches, due to air in the refrigerator's new plumbing lines. To begin ice production pull out the icecream shelf and switch to the ON position ("I") then replace shelf. If no ice is dispensed it will take about 2 days to fill the storage container. The ice maker turns off automatically when the ice container is full. To stop ice production, turn the switch to the OFF position ("O") (See diagrams on page 4). [. . . ] Other strange sounds may mean that you need to check and take action. For example, noises may mean that: · There are vibrations from an object on top of or behind or beside the refrigerator. Remember it is quite normal for noise to seem louder just after the refrigerator starts operating. Check that the appliance has enough clearance at the sides, back and top. [. . . ]