User manual AEG-ELECTROLUX ERC 37320

[. . . ] Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. For the safety of life and property keep the precautions of these user's instructions as the manufacturer is not responsible for damages caused by omission. [. . . ] Until the corresponding icon appears You must confirm the choice by pressing key (E) within few seconds. You will hear the buzzer and the icon remains lighted. In this condition any possible operation through the keys does not cause any change as long as this function is activated. It is possible to de-activate the function at any time by pressing key (D) until the corresponding icon will flash and then key (E). Shopping Function If you need to insert a large amount of warm food, for example after doing the grocery shopping, we suggest activating the Shopping function to chill the products more rapidly and to avoid warming the other food which is already in the refrigerator. The Shopping function is activated by pressing key (D) (several times if necessary) until the corresponding icon appears . You must confirm the choise by pressing key (E) within few seconds. You will hear the buzzer and the icon remains lighted. The Shopping function shuts off automatically after approximately 6 hours. It is possible to de-activate the function at any time by pressing key (D) until the corresponding icon will flash and then key (E). Eco Mode Function The Eco Mode function is activated by pressing key D (several times if necessary) until the corresponding icon appears (or setting the temperature at +5°C). Bottle rack Place the bottles (with the opening facing front) in the pre-positioned shelf. Some models have a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs. All parts inside the drawer can be removed for cleaning purposes. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Do not move the lower door shelf to ensure correct air circulation. This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level. Do not open the door frequently or leave it open longer than absolutely necessary. ⷠIf the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. [. . . ] Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Location To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the Cabinet and the wall unit must be at least 40 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the equipment can be removed. In this case, the space behind the top cupboard must be at least 50 mm deep. [. . . ]