User manual AEG-ELECTROLUX ERCG9030AS

[. . . ] ModelERCM9010AS Powersupply:220-240volts50Hz. Lights:2x20watt12volthalogen. Additional items required for installation ·Fixingsrequiredtoattachmainbodymountingbrackets and anti tilt fixings. ·Fixingsrequiredtoattachexhaustcovermounting brackets to the ceiling. electrolux e:line rangehoods important safety instructions 3 Important safety instructions This manual explains the proper use of your new E:Line canopyrangehood. Pleasereadthismanualcarefully before using the product. This manual should be kept in a safe place for handy reference. [. . . ] Removetheprotectiveplasticfilmfromthehoodbody and hang hood on the mounting brackets then secure at theanti-tiltlocationsasindicatedindiagramleft. Depending on the preferred installation/ducting mode, followstep5aor5bbelow. Using the centre line, R secure the ceiling mount bracket to the wall using suitablescrews. AttachtherecirculatingT-piece (optionalkitAR600RKformodelsERCM9010and ERCE9020, orAR600RKGformodelERCG9030)to the ceiling mount bracket. Install flexible pipe between T-pieceandfantransitionoutlet. Usecabletiesor suitableducttapetosecureflexiblepipetoT-piece. NOTE: When installed in recirculation mode, it is recommended to use a carbon filter (included in recirculation kit AR600RK for models ERCM9010AS and ERCE9020AS, or recirculation kit AR600RKG for model ERCG9030AS, refer to page 9) to prevent odours being emitted back into the room. The canopy rangehood has been D supplied with flexible exhaust pipe and duct transition piece, alternativelya150mmdia. non-combustibleflue pipe can be used. Continue the centre line to the ceiling. Attach the ceiling mount bracket on the centre line. Fit preferred flue pipe to the fan transition duct. Using a spirit level mark a vertical centre line on the wall where the hood is to be positioned, and a horizontal line at the hood base position (refer diagram bottom left). NOTE: The height of the underside of the hood body must be a minimum of 600mm above an electric cooktop & 650mm above a gas cook top and a maximum height of 800mm (see table right). ERCM9010AS & ERCE9020AS ERCG9030AS electrolux e:line rangehoods installation / using the rangehood 6 Installation NOTE: For ducted mode, we recommend extending flue pipe through the roof to external "china hat" to vent exhaust externally. We do not recommend venting into ceiling cavity. NOTE: Installation must be in accordence with local building regulations. NOTE: To ensure optimum performance of the rangehood, the use of rigid ducting is recommended. Rigid flexible ducting is suitable, although loose flexible ducting is unacceptable. All ducting must be fire retardant. Using the rangehood ­ ERCM9010AS Installation of telescopic exhaust covers Separate the inner and outer exhaust covers, and carefully remove the protective coating from both. Carefully reassemble the inner and outer exhaust covers sections by sliding the inner into the outer exhaust cover. Carefully lower the assembled inner and outer exhaust covers onto the top of the cooker hood body, and insert the exhaust cover into therangehoodbodyapproximately5mm. Fixinner(top) exhaust cover to the ceiling mounting bracket with screws supplied. Ensure that the inner (top) section is extended. To operate Canopy Depress any of the fan symbols, depending on desired fan speed, toturnthecanopyon. DepresstheOFFbuttonto turn canopy off. Setting the power level required Allbuttonshaveback-litsymbols. Fan operation ­ select speed to suit cooking conditions. Low ­ light frying/boiling Medium ­ frying/wok cooking/heavy boiling High ­ grilling, intensive frying and wok cooking ERCM9010AS ERCE9020AS ERCG9030AS To switch Lights ON and OFF Depressthe`light'buttontoturnthelightsONanddepress `light'buttonagaintoturnthelightsOFF. Using the Timer At the end of cooking if the timer is switched on, the rangehoodwillcontinuetorunforanadditional5minutes to remove any odours that remain at the completion of cooking. After5minutesthecanopywillturnitselfOFF. Auto Off Depress`autooff'buttontoturnthetimerONanddepress `auto off' button again to cancel the timer function. Care must be taken to ensure the screws are not cross threaded when attaching the outer flue cover. [. . . ] You may not make a claim under this warranty unless the defect claimed is due to faulty or defective parts or workmanship. Electrolux is not liable in the following situations (which are not exhaustive): (a) The Appliance is damaged by: (i) accident (ii) misuse or abuse, including failure to properly maintain or service (iii) normal wear and tear (iv) power surges, electrical storm damage or incorrect power supply (v) incomplete or improper installation (vi) incorrect, improper or inappropriate operation (vii) insect or vermin infestation. (b) The Appliance is modified without authority from Electrolux in writing. (c) The Appliance's serial number or warranty seal has been removed or defaced. [. . . ]