User manual AEG-ELECTROLUX ESF6529

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. [. . . ] Before the start of the washing programme put the "3 in 1" detergent in the detergent dispenser. NOTE: If the drying results are not satisfactory we recommend that you: 1. Fill up the rinse aid dispenser with rinse aid. Set the rinse aid dosage to position 2. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergents that integrate also antiglass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. 10 Washing programmes Programme Degree of soil and type of load Press the programme button Cycle description (4) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Intensive 70°C Heavy soil. Crockery, cutlery, pots and pans 70° Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C or 50°C 1 or 2 warm rinses 1 hot rinse Drying 120 - 130 1, 7 - 1, 9 23 - 25 (1) Automatic 65°C-50°C Normal soil. Crockery and cutlery AUTO 65°50° 103 - 126 1, 2 - 1, 6 12 - 25 (2) Quick 65°C Fresh soil. Crockery and cutlery Speed 65° Main wash up to 65°C 1 hot rinse Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying 30 0, 8 9 (3) Bio 50°C Normal soil. Crockery and cutlery 150 1, 05 16 50° (1) Automatic washing programme During the Automatic washing programme the amount of soil on the dishes is determined by how cloudy the water is. Switch off the dishwasher by pressing the On/Off button, the On/Off indicator light turns off. Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Setting and starting the programme with "delay start" Set the delay start before selecting a washing programme. Press the delay start button until the indicator light corresponding to the chosen hours flashes (3h, 6h or 9h) Press the button corresponding to the required programme (see "Washing programmes" chart). After about 3 seconds from the last pressure of a button the countdown starts automatically. The countdown will decrease with steps of 3 hours. The opening of the door will not modify or interrupt the countdown. Once the delay start has elapsed the programme will start automatically. 9. Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. [. . . ] Make sure that the socket and plug are compatible without having to use any type of adaptor. If necessary, have the domestic wiring system socket replaced. To isolate the dishwasher from mains, remove the mains plug. The plug must still be accessible after the appliance has been installed. [. . . ]