User manual AEG-ELECTROLUX ESF6549

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q When finishing loading or unloading close the door, as an open door can be a hazard. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] A chemical reaction can occur between silver cutlery and stainless steel cutlery. Iron and cast iron objects can rust and stain other items. Aluminium tends to go black, copper, pewter and brass tend to stain. If in doubt check with manufacturer of the item. When buying new dishes, ensure that they are dishwasher proof. For best washing results Before loading, remove all scraps of food and soak very heavily soiled pots and pans. Arrange saucepans, cups and glasses etc. Tilt items with convex or concave surfaces so that the water drains off easily. Avoid contact between the dishes as far as possible. 13 Washing programmes Programme Degree of soil and type of load Required push buttons Recommended quantity of detergent wash prewash Hot prewash Main wash up to 70°C 1 cold rinse 1 hot rinse Active dry Cycle description * 70° 80' Heavy soil. Crockery, cutlery, pots and pans ON-OFF + 70° 80' 15 g 10 g 65° Normal soil. Crockery and cutlery ON-OFF + 65° 20 g 5g Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Active dry ** 65° Fresh soil. Crockery and cutlery ON-OFF + 65° 25 g / Main wash up to 65°C 1 hot rinse *** 50° Normal soil. Setting and starting the programme with DELAY START The setting of the delay start occurs before selecting the programme. Press the DELAY START push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen hours flashes. Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. The start of the countdown will occur after about 6 seconds from the last pressure of a push button (programme or HALF LOAD push button). The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours. 15 7. Close the dishwasher door During the countdown the only indicator lights illuminate are the programme light and the light of the number of hours to the start of the programme. Once the delayed time has elapsed the programme will start automatically. It is possible to stop a countdown in progress or before it starts, simply pressing the DELAY START push button until the indicator lights of the hours are off: Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 9. To cancel a programme in progress A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off. Only the ON-OFF indicator light will remain on once the programme has been cancelled. [. . . ] If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose made quick-coupling tap such as the Pressblock. 21 Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet siphon, securing it if necessary with a clip. [. . . ]