User manual AEG-ELECTROLUX ESF66070XR

[. . . ] Subject to change without notice Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. The manufacturer is not responsible if an incorrect installation and use causes damage. Children and vulnerable persons safety · Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge to use the appliance. [. . . ] If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). These minerals and salts can cause damage to the appliance. Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. ­ The indicator light for function button A continues to flash. ⭠The display shows the current adjustment. Press the function button A again and again until the display shows the necessary adjustment. If the water softener is set electronically to the level 1, the salt indicator light stays off. Press and hold function buttons B and C until the indicator lights of function buttons A, B and C start to flash. Fill the salt container with 1 litre of water (only for the first time you fill with salt). Use the funnel to fill the salt container with salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. It is correct that water comes out from the salt container when you fill it with salt. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . Press the lid until it locks into position. Use long washing programmes when you use the detergent tablets. These cannot fully dissolve with short washing programmes and can decrease the washing results. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. Fill the rinse aid dispenser 3 with rinse aid. [. . . ] ­ The indicator light for function button B continues to flash. ­ The display shows the new adjustment. Switch off the appliance to keep the operation. If the hot water comes from alternative sources of energy, (e. [. . . ]