User manual AEG-ELECTROLUX ESF66085XR

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q When finishing loading or unloading close the door, as an open door can be a hazard. Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] If in doubt check with manufacturer of the item. When buying new dishes, ensure that they are dishwasher proof. For best washing results Before loading, remove all scraps of food and soak very heavily soiled pots and pans. Arrange saucepans, cups and glasses etc. Tilt items with convex or concave surfaces so that the water drains off easily. Avoid contact between the dishes as far as possible. The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. To ensure that your dishwasher functions perfectly, Zanussi recommends using Calgonit System, a unique and complete product, tested by millions of householders. Calgonit System includes Calgonit detergent, rinse aid, salt, machine detergent and Citro-Fresh. It is able to fulfil the main requirements for clearing both the crockery and the machine itself. 38 Washing programmes Type of load Degree of soil Required push buttons Recommended quantity of detergent wash prewash Hot prewash Main wash up to 70°C 1 cold rinse 1 hot rinse Active dry Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Active dry Cycle description * Intensive 70° 80' Heavy soil. Crockery, cutlery, pots and pans On/Off + 20 g 10 g 70° 80' On/Off + 25 g 5g Normal 65° Normal soil. Crockery and cutlery 65° On/Off + 20 g / ** Quick 65° Main wash up to 65°C 1 hot rinse 65° On/Off + 25 g 5g Cold prewash Main wash up to 50°C 2 cold rinses 1 hot rinse Active dry *** BIO 50° Normal soil. Crockery and cutlery 50° * Ideal for washing a complete load of 12 place settings with normal soil. Once the delayed time has elapsed the programme will start automatically. 5. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart. Close the detergent dispenser lid. 7. Setting and starting the programme without delay start Press the push button corresponding to the wanted programme: the indicator light corresponding to the programme illuminates and the phase indicator lights foreseen for that programme start flashing. 40 It is possible to stop a countdown in progress or before it starts, simply pressing the delay start push button until the indicator lights of the hours are off. 9. To cancel a programme in progress A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off. Only the On/Off indicator light will remain on once the programme has been cancelled. It is now possible to select a new washing programme. Important!In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape. 10. [. . . ] For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto either a 3/4 inch gas thread spout, or to a purpose made quick-coupling tap such as the Press-block. Be sure to incorporate the filter (A) supplied with the machine onto the joint. CA02 A 47 The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it if necessary with a clip. Hooked over the edge of the sink using the special curved plastic guide provided. [. . . ]