User manual AEG-ELECTROLUX ESF66811X

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 77 78 79 81 81 82 83 84 85 88 89 90 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Cutlery dimensions for mini cutlery basket Upper basket in higher position Upper basket in lower position maximum 15 cm maximum 20 cm Soft spikes Soft spikes impede glassware to move during the washing cycle or when the upper basket is moved. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Carefully lift both sides upwards and then allow the mechanism to drop back down slowly, keeping hold of it. activate/deactivate the ''Multitab function'' before the start of a washing programme. Once the programme is running, the "Multitab function " can NO longer be changed. If you want to cancel the "Multitab function " you have to cancel the programme setting and then deactivate the ''Multitab function''. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multitab function Simultaneously press and hold the two Multitab buttons (function buttons D and E) until the Multitab indicator light comes on. this means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the Multitab function symbol goes off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the Multitab function active. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C turn off while the light of function button B continues to flash. To change the setting, press button B again, the digital display shows the new setting. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Programme progress display is fully on with a blue light. Close the dishwasher door, the programme starts automatically. programme progress display gradually shows the progress of the washing programme. [. . . ] This appliance complies with the applicable plumbing regulations. Water drain connection The end of the drain hose can be connected in the following ways: This will prevent waste water from the sink running into the machine. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. [. . . ]