User manual AEG-ELECTROLUX ESF66820

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Multi-tab function Select and start a washing programme 76 78 79 80 80 81 82 83 84 88 89 90 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Once this function is selected it will remain active for all following wash programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. When using the "Multitab function", the cycle durations may change. If this is the case, the running time for the programme is automatically updated on the digital display. activate/deactivate the ''Multitab function'' before the start of a washing programme. Once the programme is running, the "Multitab function " can NO longer be changed. If you want to cancel the "Multitab function " you have to cancel the programme setting and then deactivate the ''Multitab function''. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multitab function Simultaneously press and hold the two Multitab buttons (function buttons D and E) until the Multitab indicator light comes on. this means that the function is active. To deactivate the function press the same buttons again until the indicator light corresponding to the Multitab function symbol goes off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the Multitab function active. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. To change the setting, press button B again, the digital display indicates the new setting. If you decide to revert back to the use of individual detergents we advise that you: Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. When a programme has been selected the corresponding light comes on. the programme in progress indicator light comes on. Close the dishwasher door, the programme starts automatically. [. . . ] to the sink outlet spigot , securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. [. . . ]