User manual AEG-ELECTROLUX ESL47020

[. . . ] Safety information Product description Control panel First use Setting the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function Select and start a washing programme 2 3 4 6 6 7 8 8 9 12 13 14 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Once this function is selected it will remain active for all following wash programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. When using the multitab function, the cycle duration may change. activate/deactivate the multitab function before the start of a washing programme. Once the programme is running, the multitab function can NO longer be changed. If you want to cancel the multitab function you have to cancel the programme setting and then deactivate the multitab function. In this case you have to set a washing programme (and desired options) again. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. The activation/deactivation of the rinse aid is only possible with the Multitab function active. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. The lights of function buttons A and C go off while the Light of function button B continues to flash. To change the setting, press function button B again, the digital display shows the new setting. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. When a washing programme operates, no options can be set. Close the appliance door, the programme starts automatically. Setting and starting the programme with delay start 1. Press the delay start button until the flashing number of hours for the delay start shows in the digital display. Close the appliance door, the countdown starts automatically. Close the door; the countdown will continue from the point at which it was interrupted. [. . . ] This will prevent waste water from the sink running into the machine. The waste connection must be at a maximum height of 60 cm from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the drain hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. [. . . ]