User manual AEG-ELECTROLUX ESL67070R

[. . . ] Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. The manufacturer is not responsible if an incorrect installation and use causes damage. Children and vulnerable persons safety · Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge to use the appliance. [. . . ] Setting mode The appliance must be in setting mode for these operations: · The appliance is not in setting mode when: ­ The display shows the duration of a washing programme or a delay start. ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. Press and hold function buttons B and C until the indicator lights of function buttons A, B and C start to flash. ­ The display shows the new adjustment. Switch off the appliance to keep the operation. Do the above procedure to activate again the audible signals. Be sure that the set level of the water softener agrees with the water hardness in your area. Fill the salt container with dishwasher salt. Fill the rinse aid dispenser with rinse aid. Load cutlery and dishes into the appliance. Set the correct washing programme for the type of load and soil. Fill the detergent dispenser with the correct quantity of detergent. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). These minerals and salts can cause damage to the appliance. Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Press and hold function buttons B and C until the indicator lights of function buttons A, B and C start to flash. ­ The indicator light for function button A continues to flash. / 5 inExample: the display shows termittent audible signals = level 5. Press the function button A again and again until the display shows the necessary adjustment. If the water softener is set electronically to the level 1, the salt indicator light stays off. Fill the salt container with 1 litre of water (only for the first time you fill with salt). [. . . ] ) Product number (PNC) Serial number (S. Possible cause The selected washing programme was not applicable for the type of load and soil. The baskets were not loaded correctly, water did not touch all surfaces. The spray arms could not turn freely because of incorrect arrangement of the load. [. . . ]