User manual AEG-ELECTROLUX ESL68060

[. . . ] Safety information Product description Control panel Display First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Loading cutlery and dishes Use of detergent Multitab function 2 3 4 6 6 6 7 8 9 10 14 15 Select and start a washing programme Unloading the dishwasher Washing programmes Care and cleaning What to do if. Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] This detergent will be used during the prewash phase. Fill the detergent dispenser (1) with detergent. Close the lid and press until it locks in place. Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. This appliance is equipped with the multitab function, that allows the use of combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ("3 in 1", "4 in 1", "5 in 1" etc. Check whether these detergents are suitable for your water hardness. Once this function is selected it will remain active for all following wash programmes. The programme duration can increase if you use the multitab function. activate or deactivate the multitab function before the start of a washing programme. You cannot activate or deactivate the multitab function when the programme operates. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. If you decide to revert back to the use of individual detergents we advise that you: 1. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. When a washing programme operates, no options can be set. Close the door; the countdown will continue from the point at which it was interrupted. Hot steam may escape when the door is opened. [. . . ] The waste connection must be at a maximum height of 60 cm from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the drain hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. The total length of the drain hose, including any extension you might add, must be no longer than 4 metres. [. . . ]