User manual AEG-ELECTROLUX ETN1042R 1KOK

[. . . ] Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. Never force to open the door of the machine while the machine is running. [. . . ] · Adjust the program knob to the program you desire. (You can select the program that you desire from Table-1). · The program ready light will be on. · By pressing the start/pause button, run the program which you have selected. Cancellation of the Program If you desire to end a running program early: · Press the start/pause button. · Turn the program knob to O(off) status. · Turn the program knob to "Draining" or "Spinning" programs. · The program ready light will be on. · Run the program you have selected by pressing the start/pause button. Program ending · Your machine will automatically stop when the program you have selected ends. · The program end light will be on. · Turn the program knob to O(off) position. · Take off the leftover detergent avoid to drop into your machine. · After drying the detergentdrawer put into the housing in the same manner you pull out. DIAGRAM-1 DIAGRAM-2 18 SIPHON PLUG Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 °C, do the following when it will not be in use: · Plug in the machine. · Close the water tap and pull out the water inlet hose or hoses from the tap. · Place the ends of the water drain and water inlet hoses in a cup on the ground. · Adjust the program knob to "Draining" program. · The program ready light will be on. · Run the program by pressing the start/pause button. [. . . ] Press the start/pause button. In order to stop the foam, dilute one table-spoon of softener in half liter of water and pour it in the detergent drawer. Press the start/pause button after 5-10 minutes. Arrange the amount of the detergent properly in the next washing process. Use only the detergents produced for full automatic machines. (see Table-1) Use more detergent according to the detergent. Wrong detergent has been used. The washing result is bad. Your laundry too dirty for the program you have selected. The amount of detergent used is not sufficient. 23 FAILURE PROBABLE CAUSE Clothes exceeding the maximum capacity has been filled in your machine. The washing result is not good. Your water may be hard. [. . . ]