User manual AEG-ELECTROLUX EVY7800AOX

[. . . ] This book contains valuable information about operation, care and service. You expect all this from Electrolux…and we deliver. 61 ENG Environmental advice The packaging material used is recyclable; we recommend that you separate plastic, paper and cardboard and give them to recycling companies. According to WEEE (Waste of Electrical and Electronic Equipment) guidelines, waste from electrical and electronic devices should be collected separately. [. . . ] Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins on front and rear coils. Make sure air conditioner does not fall during installation. 3/4" screws 7 ENG Lock frame (for wooden windows) Lock frame (For Vinyl-clad windows) 2 Sash lock 1 Weather seals (6"x3/4"x1/12") 5 Window sash seal foam 1 3/8" Screw 4 Top rail 1 Save carton and these installation instructions for future reference. The carton is the best way to store unit during winter, or when not in use. Do not use any screws other than those specified here. Where applicable, the top rail must be securely fastened with all four (4) screws for safety reasons. ENG 2 39 electrolux installation installation electrolux 40 Installation Before installing, the top rail must be assembled on the unit: 1. Remove the air conditioner from the carton and place on a flat surface. Remove top rail from the rear of the packaging material as shown in Fig. Align the hole in the top rail with those on the top of the unit as shown in Fig. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained. 6B Inside Outside Vinyl-Clad Windows ENG 43 electrolux installation installation electrolux 44 Extend the side panels out against the window frame (FIG. For wooden windows: Drive 3/4" (19 mm) locking screws through the frame lock and into the sill (FIG. NOTE: To prevent window sill from splitting, drill 1/8" (3mm) pilot holes before driving screws. Drive 3/4" (19 mm) locking screws through frame holes into window sash (FIG. 9A Vinyl-Clad Windows Place the frame lock between the frame extensions and the window sill as shown (FIG. For Vinyl-Clad windows: Drive 3/4" (19 mm) locking screws through the frame lock and into the window sash (FIG. NOTE:Before driving the screws, use a drill to drill 5 holes through the holes in the frame lock and frame extensions into the windows sash as shown ( FIG. 9B Wooden Windows ENG 45 electrolux installation installation electrolux 46 To secure lower sash in place, attach right angle sash lock with 3/4" (19mm) screw as shown (FIG. 11 Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. 12B It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. [. . . ] Or instead of washing, you may vacuum the filter clean. Be sure to unplug the air conditioner to prevent shock or ENG 57 electrolux normal sounds solutions for problems electrolux 58 Normal sounds 1 Solutions for problems Before calling for service, review this list. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Replace fuse with time delay type or reset circuit breaker. [. . . ]