User manual AEG-ELECTROLUX EWB85215W

[. . . ] EWB 85215 W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN WASHING MACHINE USER MANUAL 2 electrolux PRODUCT DESCRIPTION 1 2 1 2 3 4 5 The control panel Lid handle Filter access cover Lever for moving the appliance Adjustable levelling feet 3 4 5 CONTROL PANEL 1 2 3 4 5 6 1. 6. Programme selector Spin speed selector Pushbuttons and their functions Lights of cycle progress “Start/Pause” pushbutton “Delay start” pushbutton electrolux 3 DISPENSER BOX Prewash Wash Softener (do not fill above the MAX symbol M ) SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. [. . . ] SELECTING THE TEMPERATURE Press the “Temperature” pushbutton repeatedly to increase or decrease the temperature (see “Programmes table”). SELECTING THE SPIN SPEED Turn the spin speed selector on the desired position. The maximum spin speeds are : for Cottons, Synthetics, Lingerie, Wool/ Handwash, Eco, Easy iron : 800 rpm, for Delicates, Mini programme, Curtains, Blanket : 700 rpm. At the end of the programme, if you have or “Night silence selected “Rinse hold” plus” , you then need to select a “Spin” or “Drain” programme to finish the cycle and empty the water. Night silence plus : this cycle eliminates all spin speed phases and ends with rinse hold. This cycle is very quite and can be used during the night. SELECTING OPTIONS You must select the different options after selecting the programme and before presspushbutton (see ing the “Start/Pause” “Programmes table”). Press the desired button(s) : the corresponding lights come on. If one of the options is not compatible with the se- A A • Open the lid of the appliance. • Open the drum by depressing the locking button A1) : The two shutters unlock automatically. • Load the washing, close the drum and the lid of your washing machine. Before closing the lid of your appliance, ensure that the drum is properly closed : • When the two shutters are closed, • locking button A released. PROPORTIONING OF DETERGENTS Pour the amount of washing into the washand prewash compartments if ing you have selected the “prewash” option. Pour fabric softener into the compartment if necessary. SELECTION OF DESIRED PROGRAMME Turn the programme selector to the required programme. The “Start/Pause” pushbutton flashes green. If you turn the programme selector to another programme while a cycle is in progress, the appliance will ignore the new se1) Depending on model. 6 electrolux lected programme, the “Start/Pause” pushbutton flashes red. “PREWASH” OPTION (PREWASH) The appliance runs a prewash at 30°C max. “DAILY” OPTION (DAILY) This option allows to run a wash cycle of lightly soiled laundry at reduced time. “SUPER QUICK” OPTION (SUPER QUICK) The washing time will be reduced depending on the programme selected. “RINSE PLUS” OPTION The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. [. . . ] DISPENSER BOX To clean, proceed as follows : 1 2 3 4 DRAINAGE FILTER Clean the filter located at the base of the appliance regularly : 1 2 3 electrolux 9 5 4 6 7 WATER INLET FILTERS To clean, proceed as follows : OPERATING PROBLEMS Numerous checks were carried out on your appliance before it left the factory. However, should you notice a malfunction, please Problems The washing machine doesn’t start or doesn’t fill: refer to the sections below before contacting the after-sales service. Causes • the appliance isn’t plugged in correctly, the electrical installation isn’t working, there is a power failure, • the lid of your appliance and the drum shutters aren’t closed firmly, • the programme start command hasn’t been properly selected, • the water supply has been cut off, the water inlet tap is closed, • the water inlet filters are dirty, • a red tab appears on the water inlet hose1). • the drainage U-piece is fixed too low (see installation section). • the drain hose is blocked or bent, • the drainage filter is obstructed, • the out of balance detector has been activated : washing is unevenly distributed in the drum, • the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have been selected, • the height of the drainage U-piece is unsuitable. [. . . ]