User manual AEG-ELECTROLUX EWB95205W

[. . . ] installation · Unpack or ask for the appliance to be unpacked immediately upon delivery. Check the outside of the appliance is not damaged in any way. Report all transit damage to your retailer. Connection to the water supply must be carried out by a qualified plumber. [. . . ] "Super quick" option The washing time will be reduced depending on the programme selected. "Extra Rinse" option The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. "Delay start" This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the "Delay start" pushbutton. You can change or cancel the delayed start time at any time before you press the "Start/ Pause" pushbutton by pressing the "Depushbutton again (when all inlay start" dicators are off, the wash programme will start immediately). If you have already pressed the "Start/ Pause" pushbutton and you want to change or cancel the delayed start, proceed as follows : · To cancel the delay start and start the cycle immediately, press "Start/Pause" and then "Delay start" . To change the timer delay period, you must go through the "Stop" position and reprogramme your cycle. the lid will be locked during the delayed start time. If you need to open it, you must first pause the appliance by pressing the "Start/Pause" pushbutton. After closing the lid again, press the "Start/Pause" pushbutton. It is normal for the programme selector to remain stationary during the cycle. the light corresponding to the current cycle is illuminated. + : Prewash + Wash + : Rinses + Spin : End of cycle Interrupting a programme Adding washing during the first 10 minutes pushbutton : Press the "Start/Pause" the corresponding light will flash green while the appliance is paused. The lid can only be Stand by : once the programme has finished after a few minutes the energy saving system is enabled with the pilot Opened around 2 minutes after the washing machine has come to a stop. press the "Start/Pause" pushbutton again to continue the programme. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/Pause" pushbutton. If the modification is not pospushbutton flashsible, the "Start/Pause" es red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position . End of the programme The washing machine stops automatically, pushbutton goes out the "Start/Pause" and the light "End of cycle" comes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. By pressing any button the appliance will come out of the energy saving status. [. . . ] Tighten the ring nut back and make sure there are no leaks. Place everything in a drainage point (or in a sink) at a height of between 70 and 100 cm. Air must be able to enter the end of the hose, to avoid any risk of siphoning. The appliance must not be connected with an extension lead or multi-plug adaptor. [. . . ]