User manual AEG-ELECTROLUX EWT106415W

[. . . ] EWT 106415 W . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN WASHING MACHINE USER MANUAL 2 electrolux 1 1. 5. The control panel Lid button Filter access cover Lever for moving the appliance Adjustable levelling feet 2 3 4 5 CONTROL PANEL 1 2 3 4 5 6 1. [. . . ] The “Start/Pause” pushbutton flashes green. If you turn the programme selector to another programme while a cycle is in progress, the appliance will ignore the new selected programme. “Err” flashes and the pushbutton flashes red for “Start/Pause” a few seconds. SELECTING THE TEMPERATURE Press the “Temperature” pushbutton repeatedly to increase or decrease the temperature (see “Programmes table”). SELECTING THE SPIN SPEED pushbutton to change Press the “Spin” the spin speed. The maximum spin speeds are : for Cottons, Eco, Wool/Handwash, Lingerie, Jeans : 1000 rpm, for Synthetics, Easy iron, Intensive sport : 900 rpm, for Delicates, Silk, Sport : 700 rpm. At the end of the programme, if you have or “Night silence selected “Rinse hold” plus” , you then need to select a “Spin” or “Drain” programme to finish the cycle and empty the water. Night silence plus : this cycle eliminates all spin speed phases and ends with rinse hold. This cycle is very quite and can be used during the night. SELECTING OPTIONS You must select the different options after selecting the programme and before presspushbutton (see ing the “Start/Pause” “Programme table”). Press the desired button(s) ; the corresponding lights come on. If one of the options is not compatible with the selected programme, “Err” flashes on the dispushbutton play and the “Start/Pause” flashes red. “PREWASH” OPTION The appliance runs a prewash at 30°C max. “RINSE PLUS” OPTION The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. Temporary : Press the “Rinse plus” pushbutton. The option is only active for the selected programme. Permanent : Hold down the “Prewash” and “Delay Start” pushbuttons for a few seconds. The option is permanently activa- electrolux 7 ted, even if the appliance is switched off. “DELAY START” This option allows you to delay the start of a wash programme by 30, 60, 90, 2 hours to 20 hours. The selected time appears on the display for a few seconds. You can change or cancel the delayed start time at any time before you press the pushbutton, by pressing “Start/Pause” pushbutton again ( ’ the “Delay start” indicates immediate start). [. . . ] • the drainage U-piece is fixed too low (see installation section). • the drain hose is blocked or bent, • the drainage filter is obstructed, • the out of balance detector has been activated : washing is unevenly distributed in the drum, • the “Drain” programme or “Night Silence Plus” or “Rinse hold” option have been selected, • the height of the drainage U-piece is unsuitable. • • • • • too much detergent has caused foam to overflow, the detergent is unsuitable for machine washing, the drainage U-piece isn’t attached correctly, the drainage filter hasn’t been put back in place, the water inlet hose is leaking. The appliance fills but empties straight away : The washing machine doesn’t rinse or doesn’t empty : You have found water around the washing machine : electrolux 11 Problems Wash is unsatisfactory : • • • • Causes the detergent is unsuitable for machine washing, there is too much washing in the drum, the wash cycle is unsuitable, there isn’t enough detergent. The appliance vibrates, is noisy : • all packaging have not been removed from the appliance (see installation section), • the appliance isn’t level and is unbalanced, • the appliance is too close to the wall or furniture, • washing is unevenly distributed in the drum, • the load is too small. the water inlet filters are dirty, the power or water supply has been cut off, the motor overheating detector has been activated, the water inlet temperature is lower than usual, the foam detection security system has been activated (too much detergent) and the washing machine has begun draining the foam, • the out of balance detector has been activated: an extra phase has been added to distribute washing more evenly in the drum. [. . . ]