User manual AEG-ELECTROLUX EWT 9125 ERRATA

[. . . ] The following symbols have been used in this user guide : Important information about concerning your safety and information on how to avoid damaging the appliance. These warnings are for the safety of you and others around you. Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance. [. . . ] Pour fabric softener into the compartment if necessary . If you use another detergent type, refer to the section "detergents and additives" in the washing guide. Selection of desired programme You can find the right programme for different types of washing in the programme table (see "Programme table"). Load the washing, close the drum and the lid of your washing machine. The symbols which correspond to the different stages of the cycle are displayed ( Wash, Rinse, Drain, Spin). Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · If you turn the programme selector to another programme while a cycle is in 10 how to run a wash cycle "Err" flashes and the "Start/Pause" pushbutton flashes red for a few seconds then the current cycle display reappears. Selecting the temperature Press the "Temperature" pushbutton repeatedly to increase or decrease the temperature if you want your washing to be washed at a different temperature to the one selected by the appliance. Selecting the spin speed Press the "Spin" pushbutton to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. At the end of the programme, if you have selected "Rinse and hold" or "Night silence plus" , you then need to select *depending on model "Night silence plus" The washing machine does not empty the water after the final rinse which prevents the washing from creasing. Because there are no spin cycles, the washing programme is very quiet and can be selected at night. in Cotton and Synthetics programmes , the rinsing cycle uses more water. If the modification is not possible, "Err" flashes in the display and the "Start/Pause" pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position. End of the programme The washing machine stops automatically ; the "Start/Pause" pushbutton goes out and "0" flashes on the display. The lid can only be opened around 2 minutes after the washing machine has come to a stop. If a delayed start has been selected, the countdown appears on the display (hour by hour, then 90, and minute by minute from 60 min). During the cycle, the symbol comes on when the appliance is reaching the right temperature. How to run a wash cycle 13 We recommend leaving the lid and drum open after use to ventilate the water tank. If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. The screen light goes out and "Start/Pause" flashes slowly. To exit standby mode, simply press any pushbutton or turn the programme selector. [. . . ] If you use a detergent to remove stains, the wash cycle must be started immediately. Wash at 30°C Hand wash Do not wash Whitewashing (bleach) allowed (cold only and in diluted solution) Dry cleaning (all common solvents) Dry cleaning (all common solvents except trichlorethylene Do not dry clean Dry on clothes hanger Do not tumble dry , normally soiled work clothes, bed linen, table linen, body linen, towels. Easy iron : Reduces creasing and makes ironing easier. Spin : A spin cycle from 500 to 1100/1000* rpm after a Rinse hold (or Night silence plus). [. . . ]