User manual AEG-ELECTROLUX EXD18DA3WI

[. . . ] The refrigerant is charged at the factory. Be sure to read the safety precautions prior to servicing the unit. When servicing the unit, set the POWER SWITCH to OFF and unplug the power cord. Inspect the service cord for damage or wear. [. . . ] When the indoor humidity is lower than the setting humidity, the compressor will be off and the fan will stop operating 3 minutes after the compressor is shut down. If the indoor humidity is getting 5% higher than the setting humidity, the fan will be on immediately and the compressor will start too. 2. 3 Continuous Dehumidifying mode The compressor and the fan motor will always be on and the Continue and power indicator will be on. The LED will display the indoor humidity. 2. 4 Stop operation When the unit is stopped operation by pressing the ON/OFF button, the compressor and the fan will shut down and all indicators will be off. When the unit is restarted by pressing the ON/OFF button, the unit will start with previous set mode. Whether the defrost function starts need to be prejudged. The self-diagnosis function will just check the water-full defect. The fan motor will work same as the compressor. 2. 5 Compressor delay start When the mode is changed but the compressor does not start or the unit restart after stop working, if the compressor accord with it's starting condition, the fan motor will start immediately while the compressor will delay 3 seconds to re-start. 2. 7 Protection and failure mode 3 2. 7. 1 Water full protection. When the water tank is full , the compressor and fan motor will shut down and the water full indicator will flash with LED displaying P2. Under this situation, all button is out of service. After the water is poured, the unit will restore operating as previous setting. 2. 7. 2. 1 If the time accumulates up to 15 minutes with compressor operating and the temperature of evaporator lower than -1oC, the Anti-icing protection function will be activated. 2. 7. 2. 2 When the protection is activated, the compressor will be off while the fan motor is on with high speed, and the Turbo indicator will be on with the LED displaying P1. 2. 7. 2. 3 If the situation that compressor is off and fan is on has lasted for 6 minutes or the ON/OFF button is pressed, the unit will stop anti-icing protection function. 2. 7. 2. 4 After the Anti-icing function is completed, the unit will restore operation as previous mode or stop if the Anti-icing function is completed by pressed the ON/OFF button. When the output voltage of sensor is lower than 0. 5V or higher than 4. 95V, the unit will alarm and the LED displays E1 for humidity sensor failure and E2 for temperature sensor failure. Under this situation, the compressor and the fan motor will shut down and the Power indicator will flash at 5Hz. [. . . ] Replace if not within 10% of manufacture's rating. Replace the motor if the fan blade can't rotate freely. Pay attention to any change from high speed to low speed. Replace the motor if the speed does not change. [. . . ]