User manual AEG-ELECTROLUX EXH12HX-I

[. . . ] To fix the mounting plate with the long screws. To fix the remote control with the special screw. To fix the mounting plate with the wall plugs. Keep the following points in mind and get the customer's approval. [. . . ] Push the unit and apply the bottom hooking points to the mounting plate's support. (Take this step after cabling between the indoor and outdoor units. Pull the bottom of the unit to check that the unit is fixed in place. Drill a piping hole with 70mm diameter concrete drill or a hole saw with a 5mm down ward slant to the outside. 1 Indoor 2 Outdoor 3 Cut with a saw 4 Cap (Downward to outdoor) 5 Sleeve 5. Setting up the indoor unit Piping route For directions 1 and 3, cut out the specific zone without leaving any sharp edge. Store the pipes within the back cavity of the unit, and secure the pipes by attaching the piping holder. (Refer to steps a) and b) as shown below. ) a) Insert the top of the piping holder into the square opening. 1 Taping Detaching the unit from the mounting plate Push the " " marks at the bottom of the indoor unit and pull the bottom of the unit. When the hooks are released from the mounting plate, support the bottom of the unit and lift the unit upwards. Fix the cable with the accompanying cord holder and the short screw. Coil tape around the drain hose together with the pipes and electrical cable. (Cross-section area 2mm² or more) ­ Use a cable which is not lighter than polychloroprene sheathed flexible cord (design 245 IEC 57). ­ Be very careful not to confuse the terminal connections. Wrong cabling may damage the internal control circuit. ­ The markings on the indoor unit's terminal board must match with those of the outdoor unit. Be sure to lay the drain hose downward for smooth drainflow. 1 No trap allowed 2 Not to rise · Be careful not to allow the drain hose to rise, form a trap or leave its end in water, as shown below. 1 Not running wavy 2 No trap allowed 3 Not left in water · Coil thermal insulation around a drain hose extension, if running in the room. It is recommended to add an "intermediate air vent" when the drain hose is extended horizontally, or an "anti-back-flow air vent" when the hose is exposed to high winds Flare nut tightening torque Use pipes with thickness 0. Connect the pipes for the indoor unit first and then for the outdoor unit. [. . . ] Explain to the customer how to use and maintain the system, referring to the operation manual. Ask the customer to carefully read the operation manual. Important points to explain Whipping sound : · The system adjusts itself, by expansion or shrinkage, according to great temperature fluctuations. Running liquid sound : · A beep sound is heard and the OPERATION lamp starts flashing. [. . . ]