User manual AEG-ELECTROLUX EXS24GC4WI

[. . . ] Reserve button Push this button to reserve ON timer and OFF timer settings. Clock button Push this button to set time. Lock button When you push the LOCK button, all current settings are locked in and the remote controller does not accept any operation except that of the LOCK button. Use the lock mode when you want to prevent setting from being changed accidentally or playfully. [. . . ] If you keep the remote controller in a position that hinders proper signal transmission, a time lag of up to 15 minutes may occur. 8m TEM P C SPEE D MO DE CLO CK FAN SPE ED ON OF F TE MP CAUTIONS The air conditioner will not operate if curtains, doors or other materials block the signals from the remote controller to the indoor unit. Prevent any liquid from falling into the remote controller. Do not expose the remote controller to direct sunlight or heat. If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Use curtains to prevent the sunlight from falling on the receiver. If other electrical appliances react to the remote controller. either move these appliances or consult your local dealer. Replacing batteries AUTO TEM P CO OL DR Y SPEE D AU TO MO DE LO W CLO CK TIM ER ON TIM ER OFF HEA T FA N ME DH IGH SP FA N EE D ON OF F DIR AIR EC TIO N SW CLO ING TE MP CK OK CA NC E TIM ER EC O R U NO NN MIC ING ON L TIM ER TIM EA OF F DJ US T The remote controller uses two alkaline dry batteries (R03/LR03X2) (1) Slide the cover of the battery compartment, then replace the old batteries with new ones. (2) After step (1) is done, push the RESET button. (3) Before replacing the battery compartment cover, confirm that the display screen on the remote controller displays "0:00" and that the colon is flashing. After replacing batteries, set the remote controller clock. 4 NOTES When replacing batteries, do not use old batteries or different type batteries. Otherwise it may cause the remote controller to malfunction. ON/OFF button Push this button again to stop the air conditioner. If the AUTO mode is uncomfortable, you can select the desired conditions manually. When you select the AUTO mode, you do not have to set the fan speed. The FAN speed display will show AUTO and the fan speed will be automatically controlled. OFF AIR DIRECTION ECONOMIC RUNNING SWING OK CANCEL TIMER ON CLOCK TIMER OFF TIME ADJUST Stop 7 COOLING/FAN ONLY OPERATION Start Connect the unit with the power. The OPERATION lamp on the display panel of the indoor unit starts flashing. Mode select button (MODE) Select COOL, HEAT (cooling only type without), or FAN ONLY 2. Temperature button (TEMP . ) Set the desired temperature. Cooling 21 C or higher Heating 28 C or lower 3. Fan speed button (FAN SPED) Select any of the "AUTO" "LOW", "MED" and "HIGH" 4. ON/OFF button Push this button to start the air conditioner. The OPERATION lamp on the display panel of the indoor unit lights. [. . . ] Adjust the horizontal air flow grilles manually. Adjusting the Vertical Air Flow Direction When cooling and dehumiditying are selected, set the louver within the blue region. The air conditioner automatically adjust the vertical air flow direction in accordance with the operating conditions. . To set the air flow direction you desire Perform this function while the unit is in operation. Keep pushing the AIR DIRECTION button on the remote controller to move the louver to the desired direction. Change the vertical air flow louver direction within the range indicated. In subsequent operations, the vertical air flow is automatically set in the direction to which you adjusted the louver puusing the AIR DIRECTION button. TEM P C SPEE D MO DE CLO CK FAN SPE ED ON OF F TE MP 11 ADJUSTING AIR FLOW DIRECTION To automatically swing the air flow direction Perform this function while the air conditioner is in operation. [. . . ]