User manual AEG-ELECTROLUX F65410M0P

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multi-Tab function Simultaneously press and hold the two Multi-Tab buttons (D and E), until the "Multi-Tab function" indicator light illuminates. To deactivate the function press the same buttons again until the "Multi-Tab function" indicator light turns off. Multi-Tab function 23 If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid dispenser can only be possible with the "Multi-Tab function" active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing. The digital display indicates the current setting: = Rinse aid dispenser deactivated. To change the setting, press button B again, the digital display indicates the new setting. To memorise the operation, switch off the dishwasher by pressing the On/Off button. If you decide to turn back to the use of standard detergent system we advise that you: 1. Once the delay start has elapsed the programme will start automatically. Once the washing programme has started, a point-shaped optical signal appears on the floor beneath the dishwasher's door. This optical signal will remain illuminated for all the duration of the washing programme. If the appliance has been installed higher up with a furniture door mounted flush, the optical signal will be no longer visible. Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. 26 Unloading the dishwasher Cancelling a delay start or a washing programme in progress · Simultaneously press and hold the two programme buttons positioned over the word RESET , until all the programme button lights will illuminate. · Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to set the washing programme again. · If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Interrupt a washing programme in progress · Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. End of the washing programme · The dishwasher will automatically stop and an audible signal informs you of the end of the washing programme. [. . . ] Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. 38 Electrical connection The total length of the drain hose, including any extension you might add, must be no longer than 4 metres. The internal diameter of the extension hose must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. [. . . ]