User manual AEG-ELECTROLUX F86080VIL

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] Once this function is selected (indicator light illuminated) it will remain active also for the following washing programmes. With the use of the "Multitab function", the cycle durations may change. In this case, in the digital display, the indication of the running time of the programme is automatically updated. Once the programme is running, the "Multitab function " can NO longer be changed. If you want to exclude the "Multitab function " you have to cancel the programme setting and then deactivate the "Multitab function ". Multi-tab function 23 In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multitab function Press the Multitab button: the corresponding indicator light illuminates. To deactivate the function press the Multitab button again: the indicator light turns off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid dispenser can only be possible with the "Multitab function" active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Close the dishwasher door, the countdown starts automatically. The countdown will decrease with steps of 1 hour. The opening of the door will interrupt the countdown. Close the door; the countdown will continue from the point at which it was interrupted. Once the delay start has elapsed the programme will start automatically. Once the washing programme has started, a point-shaped optical signal appears on the floor beneath the dishwasher's door. This optical signal will remain illuminated for all the duration of the washing programme. If the appliance has been installed higher up with a furniture door mounted flush, the optical signal will be no longer visible. Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. Cancelling a delay start or a washing programme in progress · Simultaneously press and hold the two programme buttons positioned over the word RESET , until all the programme button lights will illuminate. [. . . ] Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. 38 Electrical connection The total length of the drain hose, including any extension you might add, must be no longer than 4 metres. The internal diameter of the extension hose must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. [. . . ]