User manual AEG-ELECTROLUX GA60GXI201

[. . . ] user manual Dishwasher GA60GXI201 2 electrolux Electrolux. Thinking of you. Share more of our thinking at www. electrolux. com Contents Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Product description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · The activation/deactivation of the rinse aid is only possible with the Multitab function active. Activation/deactivation of the rinse aid dispenser 1. The dishwasher must be in setting mode. 2. Simultaneously press and hold function buttons B and C, until the lights of function buttons A , B, and C start flashing. Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. The digital display indicates the current setting. Rinse aid dispenser deactivated Rinse aid dispenser activated 4. To change the setting, press button B again, the digital display indicates the new setting. To memorize the operation, switch off the dishwasher by pressing the On/Off button. If you decide to revert back to the use of individual detergents we advise that you: 1. Fill up the salt container and the rinse aid dispenser again. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. Select and start a washing programme Select the washing programme and delay start with the door slightly opened. The start of the programme or the countdown of the delay start will occur only after the closure of the door. Until then it is possible to modify the settings 1. Check that the baskets have been loaded correctly and that the spray arms are free to rotate. Press the button selection button to select the required programme. The programme number appears in the digital display (P1 - P2 - P3 etc. . . ) Refer to 'Washing programmes' chart. The indicator light of the programme selection button starts flashing. If options are to set, refer to the 'Washing programmes' chart to be sure that they can be set with the selected washing programme. Close the dishwasher door, the programme starts automatically. The phase indicator lights will go off, except for the phase under way. [. . . ] The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal di- Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher. To avoid water leakage after installation make sure that the water couplings are tight. 24 electrolux Electrical connection Warning! [. . . ]