User manual AEG-ELECTROLUX GA60GXI203

[. . . ] Subject to change without notice Before the installation and use, read this manual carefully: · For your personal safety and the safety of your property. Always keep these instructions with the appliance also if you move or sell it. The manufacturer is not responsible if an incorrect installation and use causes damage. Children and vulnerable persons safety · Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge to use the appliance. [. . . ] Press and hold function buttons B and C until the indicator lights of function buttons A, B and C start to flash. ­ The indicator light for function button A continues to flash. ⭠The display shows the current adjustment. Press the function button A again and again until the display shows the necessary adjustment. Do these steps to fill the salt container: 1. Fill the salt container with 1 litre of water (only with the first operation). Use the funnel to fill the salt container with salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. It is correct that water comes out from the salt container when you fill it with salt. If the water softener is set electronically to the level 1, the salt indicator light stays off. Press the lid until it locks into position. Different brands of detergent dissolve in different times. Some detergent tablets do not have the best cleaning results during short washing programmes. Use long washing programmes when you use the detergent tablets to fully remove the detergent. Use of rinse aid Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. Use of detergent To help the environment, do not use more than the correct quantity of detergent. follow the detergent manufacturer recommendations on the detergent packaging. Do these steps to fill the detergent dispenser: 1. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. [. . . ] Fault code The display shows The water pressure is too low. Possible cause The selected washing programme was not applicable for the type of load and soil. Possible solution Make sure that the washing programme is applicable for the type of load and soil. The spray arms could not turn freely because of incorrect arrangement of the load. [. . . ]