User manual AEG-ELECTROLUX GS60GV220

[. . . ] Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] It comes on when the washing programme is completed. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the AUTO OFF function automatically deactivates the appliance. This helps to decrease energy consumption. Press this button again and again to delay the start of the washing programme from 1 to 24 hours. Press one of these buttons again and again to set a washing programme. Each time you press a button, the display shows a number that is related to a washing programme. The dishes can be wet at the end of the programme when you open the appliance door. The appliance must be in setting mode for these operations: · ­ It is necessary to cancel the programme or the delay start to go back to the setting mode. You can hear the acoustic signals in these conditions: · To activate the acoustic signals again, do steps (1) through (7). Be sure that the set level of the water softener agrees with the water hardness in your area. Fill the salt container with dishwasher salt. Fill the rinse aid dispenser with rinse aid. Load cutlery and dishes into the appliance. Set the correct washing programme for the type of load and soil. Fill the detergent dispenser with the correct quantity of detergent. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). These minerals and salts can cause damage to the appliance. Adjust the level of the water softener if this does not agree with the water hardness in your area. Contact your local water authority to know the water hardness in your area. And you hear five · The display shows the setting of the water softener (example: acoustic signals = level 5). Press button (3) again and again to change the setting. [. . . ] With some malfunctions, the display shows an alarm code: - The appliance does not fill with water · Malfunction The appliance does not fill with water. possible cause The water tap is blocked or there is limescale on it. When the countdown is completed, the washing programme starts automatically. Possible cause The washing programme was not applicable for the type of load and soil. [. . . ]