User manual AEG-ELECTROLUX GT234N

[. . . ] Safety information Control panel First use Daily use Helpful hints and tips 40 42 44 44 46 Care and cleaning 47 What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] You confirm the choice of the temperature by pressing the key (E). Fluctuations of some degrees around set temperature are normal and does not mean any fault in the appliance. After a long period out of use it is not necessary to set again the temperature because it remains stored. Each function could be confirmed by pressing button (E). If there is no confirmation after some seconds the display will go out from the menu and return in normal condition. The following functions are indicated: Excessive temperature alarm Child Lock function Eco Mode function Action Freeze function Drinks Chill function Excessive temperature alarm An increase in the temperature in a compartment (for example due to an power failure) is indicated by: · Then it shows again the set temperature. The alarm indicator continue to flash until the normal conditions are restored. possible causes of alarm: · Large volume of fresh food was inserted. Child Lock Function The Child Lock function is activated by pressing key (D) (several times if necessary) until the corresponding icon appears . You must confirm the choice by pressing key (E) within few seconds. You will hear the buzzer and the icon remains lighted. In this condition any possible operation through the keys does not cause any change as long as this function is activated. It is possible to de-activate the function at any time by pressing key (D) until the corresponding icon will flash and then key (E). Eco Mode Function The Eco Mode function is activated by pressing key D (several times if necessary) until (or setthe corresponding icon appears ting the temperature at -18°C). You must confirm the choice by pressing key E within few seconds. You will hear the buzzer and the icon remains lighted. In this condition the chosen temperatures are automatically set (-18°C), in the best conditions for storing food. it is possible to de-activate the function at any time by changing the selected temperature in the compartment. Action Freeze Function The freezer compartment is suitable for long term storage of commercially frozen and deep-frozen food, and for freezing fresh food. The maximum quantity of foods to freeze in 24 hours is shown on the serial number plate. To freeze fresh foods, you will need to activate the Action Freeze function. Press key (D) (several times if necessary) until the corresponding icon appears . [. . . ] There are some sounds during normal use (compressor, refrigerant circulation). The lid has been opened too frequently The lid is not closed properly Solution Set a warmer temperature Do not leave the lid open longer than necessary Check if the lid closes well and the gaskets are undamaged and clean Large quantities of food to be fro- Wait some hours and then check zen were put in at the same time the temperature again Food placed in the appliance was too warm The temperature of the room that contains the appliance is too high for efficient operation Audible alarm and flashing alarm symbol There is too much frost and ice It is too warm inside the freezer Products are not wrapped properly The lid is not shut properly or do not close tightly The lid doesn't close completely The lid gaskets are dirty or sticky Food packages are blocking the lid The lid is difficult to open The lamp does not work It is too warm in the freezer The lid gaskets are dirty or sticky The valve is blocked The lamp is in stand-by. The temperature is not set correctly The lid does not close tightly or it is not shut properly The lid has been opened too frequently The lid has been opened for a long time Clean the lid gaskets Arrange the packages in the right way, see the sticker in the appliance Clean the lid gaskets Check the valve Close and open the lid. Refer to "Replacing the lamp" Set a lower temperature Check if the lid closes well and the gasket is undamaged and clean Try not to open the lid too frequently Do not leave the lid open longer than necessary Allow food to cool to room temperature before storing Try to reduce the temperature in the room where the appliance stands Refer to "Excessive Temperature Alarm" in "Control Panel" chapter Wrap the products better Check if the lid closes well and the gaskets are undamaged and clean Large quantities of food to be fro- Wait some hours and then check zen were put in at the same time the temperature again. [. . . ]