User manual AEG-ELECTROLUX HC412010GB

[. . . ] FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you'll find everything you need to keep all your AEG appliances looking spotless and working perfectly. [. . . ] The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Make sure that during the installation the appliance is not connected to electrical supply. Make sure that there is a stop tap assembled between the gas supply of house and the appliance. Installation The settings for this appliance are located on the rating plate. The present settings for the type of gas and gas pressure are on a sticker Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. This appliance is not connected to an exhaust gas outlet. It must be connected in accordance with the installation conditions that apply. Pay special attention to correct airflow. Make sure that the gas supply pressure of the appliance obeys the recommended values. The adjustable connection is fixed to the comprehensive ramp by means of a threaded nut G 1/2". Screw the parts without force, adjust the connection in the necessary direction and tighten everything. After installation always check the tightness of the connections using a soap solution. If it is possible to easily control the connection in its full area, you can use a flexible pipe. The flexible pipe is prepared for apply when: ­ it is no longer than 1500 mm; ­ it shows no throttles; ­ it is not subject to traction or torsion; ­ it does not get in touch with cutting edges or corners; ­ it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: ­ it does not show cracks, cuts, marks of burnings on the two ends and on its full length; ­ the material is not hardened, but shows its correct elasticity; ­ the fastening clamps are not rusted; ­ expired term is not due. Installation If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use. Assemble the parts, follow the same procedure backwards. Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. [. . . ] Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If after some tries the burner does not light, check if the crown and its cap are in correct positions. Do not keep the control knob pushed for more than 15 seconds. [. . . ]