User manual AEG-ELECTROLUX LAV75807

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". [. . . ] The washing program is continued. 25 Instructions for use Washing Cycle Ended/Remove Washing After a washing program has ended, END (EINDE, FIN) lights up on the program sequence display. If you selected RINSE HOLD (GEEN CENTR. , SANS ESSOR. ), the indicator next to the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) flashes. After a rinse hold, it is first necessary to pump off the water: ­ Press either the button START/PAUSE (START/PAUZE, MARCHE/ PAUSE) (water is pumped off and the washing is spun according to the program which has just run; after pressing the button START/ PAUSE (START/PAUZE, MARCHE/PAUSE) again, the spin speed can also still be changed during spinning), or ­ turn the program selector to PUMP (POMPEN, VINDAGE) and press the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off without spinning) or ­ turn the program selector to SPIN (CENTRIFUG. , ESSORAGE) or SHORT SPIN (KORT CENTRIFUG. , ESSOR. DELICAT) and press the button START/ PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off and the washing is spun or gently spun). After the end of this program step, the indicator END (EINDE, FIN) lights up. As soon as the indicator DOOR (DEUR, PORTE) lights up green, the filling door can be opened. Turn the program selector to OFF (UIT, ARRET). After washing, pull out the washing detergent drawer slightly so that it can dry out. Only lean the door against the washing machine so that the latter can air out. 3 OVERDOS. If the display OVER DOSING (OVERDOS. , SURDOSAGE) SURDOSAGE lights up, too much washing detergent was used in the washing program just ended. During the next wash, pay attention to the dosing information of the washing detergent manufacturer and pay attention to the filling quantity!Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 31 Instructions for use Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. Switch off the washing machine and pull out the mains plug before cleaning the drain pump!First carry out an emergency emptying (see section "Carry Out Emergency Emptying"). Place a towel on the floor in front of the cover of the solution pump. Unscrew the drain pump cover anticlockwise and pull it out. 1 4. [. . . ] The Customer Service stocks hoses in lengths of 2. 7 and 4m. It is absolutely essential to install the drainage hose free of pinches. Water Drainage into a Siphon The grommet on the end of the hose fits all commonly used siphon types. Secure the grommet/siphon connecting point with a hose clamp. 0 Draining the water into a basin Attention! [. . . ]