User manual AEG-ELECTROLUX MC1752EA

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. OPERATING INSTRUCTIONS IMPORTANT SAFETY INFORMATION ENVIRONMENT INSTALLATION Appliance positioning Removing transport safety packaging Electrical connection Changing door stop Special accessories PRODUCT DESCRIPTION CONTROL PANEL Control panel Display BEFORE FIRST USE PROGRAMME OVERVIEW DAILY USE Sorting laundry Average laundry weights Switching machine/drum light on Laundry loading Selecting the programme DELICATE (DELICAAT) function 82 82 84 85 85 85 86 86 87 88 89 89 89 90 90 92 92 93 94 94 94 94 SENSITIVE function 95 LONG ANTI-CREASE (ANTIKREUK LANG) function 95 BUZZER (ZOEMER) function 95 TIME (TIJD PROGR. ) function 95 DELAY START (STARTUITSTEL) 95 CHILD LOCK function 96 Starting the programme 96 Changing programme 96 Laundry unloading 97 CARE AND CLEANING 97 Cleaning fluff filter 97 Cleaning the door seal 99 Emptying the water reservoir 99 Cleaning heat exchanger 100 To clean the drum 101 Clean operating screen and housing 101 WHAT TO DO IF . [. . . ] Unscrew cover plates D from the front D E of the appliance, rotate through 180°, F F screw on the opposite side. Unscrew door lock E , push down slightD ly and remove from the front of the appliance. Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. You can select a programme duration from 10 mins to 3 hrs in 10-minute steps. With the DELAY START (STARTUITSTEL) button (7), you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h). Press the DELAY START (STARTUITSTEL) button (7) as many times as necessary until if the programme is to be the required start delay appears on the display, e. If the display is showing 20h and you press the button again, the time delay will be cancelled. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (ANTIKREUK LANG) (3) and BUZZER (ZOEMER) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. When program is started only current cycle phase is indicated by single icon. [. . . ] Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to "Description of machine" section. Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover. [. . . ]