User manual AEG-ELECTROLUX SDS41200S0

[. . . ] Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Thank you for choosing this AEG product. [. . . ] This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance are remarked by the symbol cyclable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened · In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. To turn off the appliance, turn the Temperature regulator to the "O" position. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature regulator toward higher settings to obtain the maximum coldness. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. The sliding box can be placed at different heights. do make these adjustments proceed as follow: 1. Lift the shelf with the sliding box upwards and out of the holders in the door 2. remove the retaining bracket out of the guide under the shelf 3. Reverse the above operation to insert the sliding box at a different height. This appliance is equipped with one or more trays for the production of icecubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. Do not open the door frequently or leave it open longer than absolutely necessary. [. . . ] Use the special cleaner provided, which you will find already inserted into the drain hole. A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Replace the used lamp with a new lamp of the same power and specifically designed for household appliances. [. . . ]