User manual AEG-ELECTROLUX T56647

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. Should any problems arise, this booklet provides instructions on how to solve them by yourself; see section "Something not working?". If this information is not sufficient, please contact our nearest Service centre (address and telephone numbers are indicated on the enclosed leaflet). Printed on recycled paper. [. . . ] Use a damp hand to clean the microfine filter, which is built into the lower part of the loading aperture. \ 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 17 125983250. qxp 2006-03-21 11:11 Page 18 Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Press against the large mesh filter until it locks into the interlock. If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 18 125983250. qxp 2006-03-21 11:11 Page 19 Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically and the EMPTY WATER (RESERVOIR) display will light up. In order to continue the programme, the condensate tank must first be emptied. The condensate is not suitable for drinking or for preparing foodstuffs. Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if . . . Troubleshooting by yourself If, during operation, the dryer shows an error display (one or more displays flashing on the programme progress display), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. Press the START/PAUSE (START/PAUZE) button. If the error display is still shown, please contact our after-sales service and inform them which displays are flashing. Problem Possible cause Mains plug is not plugged in or fuse is not working correctly. Remedy Plug in at mains socket. Check fuse in fuse box (domestic installation). Press the START/PAUSE (START/ PAUZE) button again. Dryer does not work. Loading door is open. Have you pressed the START/ PAUSE (START/PAUZE) button? 21 125983250. qxp 2006-03-21 11:11 Page 22 Problem Possible cause Remedy Select a different programme the next time you dry Wrong programme selected. (see "Overview of programmes" section). Ventilation slots in base area covered up. Uncover ventilation slots in base area. Residue on inside surface of Clean inside surface of drum or drum ribs. [. . . ] The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: · a chemical or electrochemical reaction caused by water, · abnormal environmental conditions in general, · unsuitable operating conditions, · contact with harsh substances. The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. [. . . ]