User manual AEG-ELECTROLUX T86580IH

[. . . ] LAVATHERM 86580IH TUMBLE DRYER USER MANUAL 2 CONTENTS 4 6 7 8 10 12 12 14 18 20 27 29 30 SAFETY INFORMATION ENVIRONMENT CONCERNS PRODUCT DESCRIPTION ACCESSORIES CONTROL PANEL BEFORE FIRST USE PROGRAMMES USING THE APPLIANCE HINTS AND TIPS CARE AND CLEANING TROUBLESHOOTING TECHNICAL INFORMATION INSTALLATION SERVICE When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Model PNC Serial Number The following symbols are used in this user manual: Warning - Important Safety information. General information and tips Environmental information Subject to change without notice ENGLISH 3 FOR PERFECT RESULTS Thank you for choosing this AEG product. [. . . ] Push the Delay start button again and again until the necessary time of the delay come into the view on if the prothe display (e. g. To activate the Delay start function, push the Start/Pause button. The time to start decreases on the display. THE ANTICREASE FUNCTION Extends of 30, 60, 90 or 120 minutes the standard anticrease phase (30 minutes) at the end of the drying cycle. This function prevents the laundry from creases. The laundry can be removed during the anticrease phase. THE SPUN AT RPM FUNCTION This function helps to set the best condition to dry the laundry. If you know the initial spin speed when you washed you can use this function. Higher spin speed causes that the laundry contains less water. CHILD LOCK FUNCTION The child lock can be set to prevent the children to play with the appliance. The child lock function locks all push buttons and the programme dial (this function does not lock Auto/Off button). To activate the child lock function push the Dry Plus and Anticrease buttons at the same time until the symbol come into view on the display. To deactivate push again the above buttons until the symbol go out of view. You can activate the child lock function: · before you push the Start/Pause button - the appliance cannot start · after you push the Start/Pause button - all the push buttons and the programme dial are deactivated THE BUZZER FUNCTION When the buzzer function is activated you can hear the buzzer at the: · cycle end · anti-crease phase start and end · cycle interruption The buzzer function is by default always on. You can use this function to activate or deactivate the sound. THE TIME DRYING FUNCTION Operates only with the Time programme. Lets the user to set special time of drying programme from minimum 10 min. steps). STARTING A PROGRAMME To activate the programme push the button as on the illustration. The LED above the button illuminates in red colour. ENGLISH 17 CHANGE A PROGRAMME To change a programme, push the On/Off button to deactivate appliance. Push the On/Off to activate the appliance and then set the programme again. To remove the laundry: 1. Push the Auto/Off button for 2 seconds to deactivate the appliance. After each drying cycle: · clean the filter · drain the water container (See chapter CARE AND CLEANING. ) AT THE END OF PROGRAMME When the drying cycle is completed, the symbol flashes on the display. If the Buzzer function is on, an acoustic signal sounds intermittently for one minute. 18 HINTS AND TIPS ECOLOGICAL HINTS · Do not use fabric softener to wash and then dry. In the tumble dryer laundry becomes soft automatically. · Use the condensate as distilled water, e. g. If it is necessary clean the condensate before (e. g. [. . . ] · If it is necessary to move the appliance, it must be moved vertically. · The appliance must not be installed behind a lockable door, a sliding door, a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the tumble dryer is restricted. UNPACKING CAUTION!Before use all parts of the transport packaging must be removed. Pull 2 plastic hoses with the polystyrene blockages out from the drum. x2 It is possible to adjust the height of the tumble dryer. [. . . ]