User manual AEG-ELECTROLUX TWSL6S7000

[. . . ] Important safety information Environment Installation Product description Control panel Before first use 51 53 53 56 56 57 Programme chart 58 Daily use 59 Care and cleaning 62 What to do if . In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] ⷠWhen operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. ⷠShould the appliance be moved, it must be transported vertically. ⷠThe appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. removing transport safety packaging Caution!Before use all parts of the transport packaging must be removed. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The power supply cable must be accessible after installing the machine. Pull off adhesive strips from inside machine on top of drum. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover 1 plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snap-on fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. Unscrew cover plates D from the front of the machine, rotate through 180°, screw on the opposite side. Unscrew door lock E , push down slightly and remove from the front of the machine. Press snap-in button F in and down, press cover down slightly and remove from front of the machine. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. [. . . ] Select time programme or higher drying level (e. E51 - only dryers with the LCD): Switch the dryer off and on. 2) follow program recommendation - see Programme overview chapter 3) see Care and cleaning chapter 4) see Machine settings chapter 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). Changing the bulb for interior lighting Only use a special bulb which is designed specially for dryers. [. . . ]