User manual AEG-ELECTROLUX X91384MI0

[. . . ] If the extractor is used in conjunction with non electrical appliances (e. Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. [. . . ] Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. Theframemountingsmustbesecuretowithstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. Inallcaseswheretheceilingisnotstrongenough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts. Connectupalltheconnectorstothesocketsprovided on the Control Board Unit, making sure they are compatible. CONNECTION IN DUCTING VERSION When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. 1 is in correspondence with the Chimney openings both horizontally and vertically. Join the Connector 15 to the Hood canopy outlet us-ing a rigid or flexible pipe ø¸150 mm, selection of which is at the discretion of the installation technician. Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Similarly, positionthelowerchimneysectionand fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. Workingfrombelow, fixthehoodcanopytothe frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely. Connect the hood to the mains through a twopole switch ha-ving a contact gap of at least 3 mm. Placetheconnectorsinthejunctionbox24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. When the button is touched with the hood turned off, all functions light up (intensity 50%) and are enabled. When the button is touched with the hood in operation, all functions are turned off and disabled (Motor Off + Lights Off). When the area is touched, the motor starts at the speed required. [. . . ] Two options are available: · Turn the hood off using the hood on/ off button · Remove power for 10 seconds and then reconnect it. the calibration procedure is carried out every time the type of hob is changed. Calibration procedure: every time the hood is turned on or the type of hob is changed, the sensor calibration procedure is run. [. . . ]