User manual AEG-ELECTROLUX Z5511 NORDIC

[. . . ] · Use only as described in this manual. Use only manufacturers recommended attachments. · Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have unit serviced before using. [. . . ] Please call 08706 055 055 for assistance. IMPORTANT: For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase. Purchased from ____________________________________________________ Date purchased __________________Model no __________________________ 101 Oakley Road, LUTON, BEDFORDSHIRE, LU4 9QQ Features of the Electrolux vacuum cleaner and accessories supplied with it are protected in Great Britain and abroad by Patents or Registered Designs. This appliance conforms with the requirements of the amended E. E. C. 89/336/EEC relating to electromagnetic compatibility (EMC) CE. Electrolux, may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteration without notice. 4 How To Assemble CAUTION: Assemble the cleaner completely before plugging into an electrical outlet. CAUTION: Moving parts, stay clear of brush roll when plugging in. NOTE: Features may vary by model yet all parts assemble the same. Step A Remove Dust Cup Dust Cup Latch Step B Attach Handle NOTE: Screws must be installed to properly secure the handle. Dust Cup Handle Handle Tabs Two Screw Locations Slots Screw Dust Cup Screw 1. Remove dust cup from unit to expose the two screw installation locations. Release the dust cup by rotating the dust cup latch to the left. Pull out and up on the dust cup handle to remove from unit. 2. Wrap electrical cord around them to store electrical cord on unit. Top hook rotates down for quick release of the electrical cord. Rotate back up to store electrical cord. Turn this fastener to the unlock position to remove the clear tube. To replace tube, place tube on the back of the unit and turn fastener to lock position. Store crevice tool here. 14 12 13 18. Place the end of the hose into hose adapter for floor/carpet cleaning. 15 16 12 Thermal Cut Off This cleaner has a special thermostat that 15 18 17 protects the cleaner in case of motor overheating. If the cleaner suddenly turns off, follow this procedure: 1. Check for source of overheating problem (i. e. full dust cup, clogged hose or clogged filters). If a full dust cup, clogged hose or clogged filters are found, empty the dust cup, unclog the hose or replace the filters. [. . . ] Push down on latch and pull out on HEPA filter door to remove. To close, place HEPA filter door on top of bottom tab, pivot door up and press door against cleaner until it latches. HEPA Filter Door 14 NOTE: Turn off the switch and unplug the electrical cord before servicing. PROBLEM Motor will not start. CAUSE 3 3 3 Electric Plug SOLUTION Push plug securely into outlet. Hint: If picking up fine dust, the bag may not look full, but a fine substance tends to reduce suction when it blocks the airflow through the paper bag and filter(s). Make sure the dust bag is installed properly. [. . . ]